User manual PHILIPS HOME THEATRE-HOME CINEMA MX920AHT

[. . . ] For this reason, when DTS-encoded software is played back through the analog outputs of the CD, LD, or DVD player, excessive noise will be exhibited. To avoid possible damage to the audio system, proper precautions should be taken by the customer if the analog outputs are connected directly to the receiver. Only for FR975 and MX980D: To enjoy DTS Digital SurroundTM playback, a DTS-compatible player has to be connected to one of the digital inputs of the receiver. System Setup Page 14 Please read the following new chapter after the "Positioning the Speakers" chapter in this section: Receiver Adjustment Once the number and position of loudspeakers has been fixed, you can adjust the initial receiver settings for optimal surround sound with the actual setup: 1 Set what speakers have been connected to the receiver (see "Menus / Speaker Setup" on page 17). Note: The initial setting of your receiver is: two front speakers left and right: present (cannot be altered) center speaker: present two rear speakers: present subwoofer: present 2 Select the size of the speakers (SMALL or LARGE) (see "Menus: Speaker Sizes" on page 17). [. . . ] 2 Check whether the power voltage as shown on the type plate corresponds to your local power voltage. If it does not, consult your dealer or service organization. 3 Connect the power cable to the power outlet. Do not connect the subwoofer to the outlets of the receiver. Note: To disconnect completely the subwoofer from the power, remove the power plug from the power outlet. L L + 9 8 7 6 5 AC MAINS SPEAKE R R L R L SU BW OOF ER LEVEL CONTRO CUT OFF FREQ UEN CY L Hz OUT + + STANDBY - ON 150 3 4 ~ R R SOURC SELEC E TOR SPEAK ER SUBW IN / WIRELESS OOFER IN 60 Hz MAX MIN SUBW OOFER PHASE IN SELEC TOR HIGH POWER SUBWOOFER 0° 180° Controls 1 STANDBY-ON y . . . . . . . . . . . . Switches the subwoofer on and to standby. 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Status light. 3 CUT OFF FREQUENCY. . . Adjusts the frequency range reproduced by the subwoofer. 4 SUBWOOFER LEVEL CONTROL Adjusts the volume of the subwoofer. Adjustment The subwoofer must be adjusted to your listening environment and to your speaker setup. 2 Play one of your favorite tracks at a normal listening level. 3 Turn SUBWOOFER LEVEL CONTROL to adjust the volume of the subwoofer. 4 Select the reproduced frequency range by turning CUT OFF FREQUENCY. 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . You may move down in an option list using X MENU NAVIGATOR ("down" key on the remote control). 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . You may move forward to the next menu topic using NEXT 2 ("right" key on the remote control). O K. . . . . . . . . . . . . . . . . . . . . . . . . . . . . You may confirm the displayed value. ON/OFF GUIDE is tuned to a preset radio station. SENS LO . . . . . . . . . . . . . . . . . . Tuner is switched to low sensitivity. C I N E M A L I N K O N . . . . . . CINEMA LINK is active STEREO. . . . . . . . . . . . . . . . . . . . . . An FM station is being received in stereo. SMART SOUND . . . . . . . . . . . One of the preset sound settings of the receiver is being used (FR 965, MX 960D only). HALL. . . . . . . . . . . . . . . . . . . . . . . . . . HALL effect is on. ANA . . . . . . . . . . . . . . . . . . . . . . . . . . Analog input is being used for the playing source. N I G H T . . . . . . . . . . . . . . . . . . . . . . . NIGHT MODE is on. COAX 1 . . . . . . . . . . . . . . . . . . . . . . Coaxial digital input COAX 1 is being used for the playing source. COAX 2 . . . . . . . . . . . . . . . . . . . . . Coaxial digital input COAX 2 is being used for the playing source. [. . . ] The level of the surround sound is not adjusted properly. The sound level of the center channel is not adjusted properly . A mono signal is reproduced. Receiver or antenna is positioned near a radiation source such as TV, CD player, CD recorder, DVD player, etc. No digital recording The sampling frequency is not accepted by possible via digital output the digital recorder. Whole recording appears The DVD player does not provide track as one track when information. [. . . ]