User manual PHILIPS HP4489

[. . . ] Always pull out the mains plug when the appliance is not being used. This product is equipped with an automatic overheating protection device. After cooling down for a few minutes, the appliance can be used again. Before reusing, check the air inlet grille for possible blockage by fluff, hair, etc. [. . . ] Use position || (maximum position) when you start styling. When the hair gets dryer, you can switch back to position |. For a longer-lasting result, set the Salon Multi Styler to the "Cool air" (1) position for a few seconds before removing the brush from your hair. The cool air will fix your wave or curl so that your style will last longer. Always switch the appliance off before removing and/or affixing the attachments. Jumbo tong - Take a (fine) lock of hair and comb it carefully. Ensure that the hair ends are also wound in the required direction (fig. Note: The finer the lock, the firmer the curl will be and the longer it will last!Keep the styler in the hair until the hair is dry and warm to the touch (fig. - Rotate the styler in the opposite direction until the clip can be opened again (fig. - For longer lasting curls and waves, switch the styler to its cool air position (1) to fix the curl and allow the hair to cool down before combing or brushing. Volume brush The Volume brush is suitable for straight and wavy hair of any length. its special design ensures that the warm air is directed at the scalp. As a result, the hair is dried in a way that ensures optimum volume and "body". For example, you can curl the hair ends outwards or inwards. This attachment can also be used to make large curls and waves. volume 10 - Insert the Volume brush into the hair. Brush against the direction of the hair growth, touching the scalp with the brush. Then rotate the attachment away from the head (fig. The hair will be lifted and fall lightly back onto the head. In this manner you add maximum volume to the hair. If the hair is still damp you can hold the Volume brush still for a moment, before you rotate it away from the head to remove it. [. . . ] - As soon as the hair is warm to the touch, switch off the appliance and carefully remove the hot air brush from the hair. - Leave the curls or waves to cool down, before finishing by combing, brushing or fingercombing the hair into its final style. To remove the brush from the hair · Large vent brush - Carefully rotate the styler in the opposite direction, just far enough to release the hair without spoiling the curl. Be careful not to pick up underlying hairs because this could cause the brush to get stuck in hair. [. . . ]