User manual PHILIPS HP4641

[. . . ] Do not use this product near or over water contained in baths, washbasins, sinks etc. If you use it in a bathroom, unplug the appliance after use, since the proximity of water presents a risk, even when the hairdryer is switched off. For additional protection we advise you to install a residual current device (RCD) with a rated residual operating current not exceeding 30mA in the electrical circuit supplying the bathroom. [. . . ] Less tight curls will require less than 8 seconds. 1 Insert the mains plug into the wall socket. Is C2 Comb or brush the hair so that itthe hair disentangled and smooth. The appliance is ready for use after approx. C The ready dot has turned from red to black. c 3 Take a lock of hair and wind it round the barrel. Make sure the end of the lock is wound in the required direction. Do not wind too much hair round the barrel at a time. The thinner the lock of hair, the tighter the curl will be. Do not wind a lock of hair more than twice round the brush. Make sure the lock of hair is in contact with the barrel. Set the appliance to your preferred speed setting. This will give your hair optimum lift and volume. For long-lasting results, direct a cool airflow at your hair to fix your style. 9 Remove the brush from your hair, by sliding the brush out of the hair without picking up underlaying hair. Make sure you hold the brush away from the underlying hair when you remove it. [. . . ] Function 10 more times, then unplug the appliance and rinse out the Cool Tip water reservoir. If the mains cord of this appliance is damaged, it must be replaced by an authorised Philips service centre, as special tools and/or parts are required. If you need information or if you have a problem, please visit the Philips Web site at www. [. . . ]