User manual PHILIPS HP4648

[. . . ] Problem The appliance does not work. www. philips. com Possiblecause You have put styling products in your hair (e. g. You have used the appliance at a temperature setting that is too high for you hair type. In some climates and surroundings, the air contains more moisture than in others. The heat of the curler causes moisture that is naturally present in the surrounding air to evaporate. [. . . ] Wait a few more minutes until the word `READY' appears on the display. Possiblecause There is a power failure or the socket to which the appliance is connected is not live. The appliance switched off automatically after having been on for 1 hour. The appliance is not suitable for the voltage to which it is connected. The mains cord of the appliance is damaged. Solution Check if the power supply works. If it does, plug in another appliance to check whether the socket is live. Set the on/off slide to `I' to switch on the appliance. Set the on/off slide to `0' and then to `I' again to switch the appliance off and on again. Make sure that the voltage indicated on the appliance corresponds to the local mains voltage. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Press and hold the temperature decrease/lock button for a few seconds until the lock symbol disappears from the display. This is normal and harmless. You have used the appliance at a temperature setting that is too low for you hair type. Never leave the appliance unattended when it is connected to the mains. Caution For additional protection, we advise you to install a residual current device (RCD) in the electrical circuit that supplies the bathroom. This RCD must have a rated residual operating current not higher than 30mA. The barrel and the clip become hot during use. Prevent the hot surfaces of the appliance from coming into contact with your skin. The maximum temperature occurs just after heating up. The actual temperature during use may be lower. For safety reasons, the appliance automatically switches off after having been on for 1 hour. Wait until the appliance has cooled down before you store it. Always switch off the appliance before you put it down, even if it is only for a moment. Do not leave the barrel in your hair for more than a few seconds at a time to prevent damage to your hair. [. . . ] This coating slowly wears away over time. This does not affect the performance of the appliance. If you use the appliance on colour-treated hair, the barrel may stain. 2 3 4 5 6 7 8 9 - 10 11 12 13 - 14 Curling - 1 Putthepluginthewallsocket. 2 Settheon/offslideto`I'toswitchontheappliance. (Fig. 2) , , Thedefaulttemperaturesettingof120appearsonthedisplay. (Fig. 3) Assoonastheappliancehasheateduptothissetting, theword`READY' appearsonthedisplay. Neverleavetheapplianceunattendedwhenitispluggedin. Alwaysputthe applianceonaheat-resistantsurfacewhenitisheatingupandwhenitishot. [. . . ]