User manual PHILIPS HP4687

[. . . ] The mains cord is damaged Check if the power supply works. If it does, plug in another appliance to check whether the socket is live. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. www. philips. com u 4222. 002. 7067. 2 EnGlISh Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. philips. This TRESemmé Philips appliance is designed and created to give you the salon styles you want, in a quick and easy way. [. . . ] Never leave the appliance unattended when it is connected to the mains. Caution For additional protection, we advise you to install a residual current device (RCD) in the electrical circuit that supplies the bathroom. This RCD must have a rated residual operating current not higher than 30mA. The straightening plates and the plastic parts near the plates reach a high temperature quickly. Prevent the hot surfaces of the appliance from coming into contact with your skin. The maximum temperature occurs just after heating up. The actual temperature during use may be lower. Wait until the appliance has cooled down before you store it. Always switch off the appliance before you put it down, even if it is only for a moment. Do not wind the mains cord round the appliance. Do not use the appliance on artificial hair. Do not use the appliance for any other purpose than described in this manual. Do not leave the plates in your hair for more than a few seconds at a time as this may cause damage to your hair. Keep the straightening plates clean and free of dust, dirt and styling products such as mousse, spray and gel. Dust, dirt and styling products may cause damage to the anodised titanium plates. If you use the appliance on colour-treated hair, the straightening plates may stain. 2 3 4 5 - Using the appliance Straighteners are powerful styling tools and must always be used with care. As with all straighteners that reach salon-high temperatures, do not use the appliance frequently to avoid damage to the hair. If you use the straightener incorrectly or if you use it at the wrong temperature setting, you could overheat your hair or even burn it. Always make sure you select a temperature setting that is suitable for your hair type. Straightening 1 Put the plug in the wall socket. , The blue power-on light goes on. - Never leave the appliance unattended when it is plugged in. Always put the appliance on a heat-resistant surface when it is heating up and when it is hot. [. . . ] Place it between the straightening plates and press the handles of the appliance firmly together. 8 Slide the straightener down the length of the hair in 5 seconds, from root to hair end, without stopping to prevent overheating (Fig. 9 Repeat this process after 20 seconds until you have achieved the desired look. Do not comb or brush it before it has cooled down, as this would ruin the hairstyle you have just created. [. . . ]