User manual PHILIPS HP4818

[. . . ] Do not use it near or over water contained in baths, washbasins, sinks etc. When you use the appliance in a bathroom, unplug it after use. The proximity of water presents a risk, even when the appliance is switched off. [. . . ] Do not insert metal objects into the air grilles to avoid electric shock. Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. check the condition of the mains cord regularly. Do not use the appliance if the plug, the mains cord or the appliance itself is damaged. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. caution For additional protection , we advise you to install a residual current device (RCD) in the electrical circuit that supplies the bathroom. This RCD must have a rated residual operating current not higher than 30mA. If there is no Consumer Care Centre in your country, go to your local Philips dealer. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, contact the Consumer Care Centre in your country. Possiblecause There is a power failure or the socket to which the appliance is connected is not live. If it does, plug in another appliance to check whether the socket is live. Before you switch on the appliance again, check the grilles to make sure they are not blocked by fluff, hair, etc. make sure that the voltage indicated on the appliance corresponds to the local mains voltage. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Set the airflow slide switch to setting I for drying short hair or styling your hair. [. . . ] Set the airflow slide switch to setting I for drying short hair or styling your hair. 4) It is recommended to use the Quick-Dry setting only briefly to avoid dehydrating your hair. Thermoprotect setting 6 The Thermoprotect setting quickly and gently dries the hair at a constant, caring temperature of 57°C. [. . . ]