User manual PHILIPS HP6364

[. . . ] 3 Insert the adapter into the wall socket. Optimising the lifetime of the battery When you first start to use the appliance, we advise youtouseituntilthebatteryiscompletelyempty beforeyourechargeit. 3 Move the appliance with the teeth of the pretrimmer pointing forwards against the direction of hair growth to precut longer hairs (Fig. [. . . ] 1 Remove the comb and/or any attachment and put the epilator attachment on the appliance. 2 Place the appliance perpendicularly onto the skin so that the epilator attachment is in proper contact with the skin. 3 Stretch the skin with your free hand to make the hairs stand upright. 4 To epilate your bikini line, move the appliance slowly against the direction of hair growth (Fig. Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. youcanalsocleantheapplianceandtheattachments , exceptfortheepilatorattachment , underthetap. 1 Switch off the appliance, pull the adapter out of the wall socket and pull the appliance plug out of the appliance. 2 Remove any attachments and clean the appliance and the attachments. 3 Insert the hook of the cutting element into the slot in the cavity and push the cutting element back onto the appliance (`click') (Fig. 2 Clean the cutter and its surroundings and the cavity in the foil frame carefully with the brush or under the tap (Fig. Cleaning the epilator attachment Never try to remove the epilating discs from the epilator attachment. do not clean the epilator attachment under the tap. , Epilation can lead to ingrown hairs or minor skin injuries, whichmaycauseinflammationsdueto penetration of bacteria into the skin. It is therefore important to clean the epilator attachment thoroughly after each use. 2 Move the trimmer attachment against the direction of hair growth. Make sure the surface of the comb always stays in contact with the skin (Fig. [. . . ] 1 Disconnect the appliance from the mains and let the appliance run until the motor stops. 4 Insert a screwdriver between the two housing halves and pry them apart (Fig. 7 Remove the battery from the plastic part with a screwdriver. [. . . ]