User manual PHILIPS HP6541

[. . . ] Register your product and get support at www. ақша 55 Lietuviškai 64 Latviešu 72 Polski 80 Română 89 Русский 97 Slovensky 107 Slovenščina 116 Srpski 124 Українська 132 HP6541 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Epilating discs 2 Epilating head 3 On/off button -- press once for speed II -- press twice for speed I -- press three times to switch off 4 Charging light (white) with battery-low indication (red) 5 Socket for small plug 6 Adapter 7 Disposable non-rechargeable batteries 8 On/off slide 9 Precision epilator 10 Cleaning brush Important Read this user manual carefully before you use the appliances and save it for future reference. [. . . ] , , The appliance starts to operate at speed II, which is the most efficient speed for epilating. Note: If you want to use speed I, press the on/off button a second time. Speed I is suitable for areas with little hair growth, for hard-to-reach areas and for areas where bones are located directly beneath the skin, such as knees and ankles. 2 Stretch the skin with your free hand to make the hairs stand upright. Place the epilating head at an angle of 90° onto the skin with the on/off button pointing in the direction in which you are going to move the appliance (Fig. -- Epilate your bikini line as shown in the figure. -- Epilate your underarms as shown in the figure. 3 Move the appliance slowly over the skin against the direction of the hair growth while pressing it lightly (Fig. 4 Press the on/off button a third time to switch off the appliance (Fig. Tip:When you epilate your underarms, use a small amount of your common shower gel to ensure better gliding. Tip:To relax the skin, we advise you to apply a moisturising cream immediately or a few hours after epilation. For the underarms, use a gentle deodorant without alcohol. overheat protection This function helps to prevent overheating of the appliance. Note:To avoid overheating of the epilator, do not press the appliance too hard onto your skin. The epilator works best when you move it over your skin without exerting any pressure. If the overheat protection is activated, the appliance switches off automatically and the charging light flashes red for 30 seconds. You can reset the overheat protection by letting the appliance cool down and then switching it on again. Note: If the charging light starts to flash red again, the appliance has not yet cooled down completely. Overload protection If you press the epilating head too hard onto your skin or when the epilating discs of the epilating head get blocked (e. ), the appliance switches off and the charging light flashes red for 5 seconds. Turn the epilating discs with your thumb until you can remove whatever is blocking the epilating discs. 10 English Using the precision epilator Inserting the batteries 1 Press the snap hooks of the lid of the battery compartment to remove it from the precision epilator (Fig. [. . . ] €22) Note: Make sure all parts are completely dry before you reassemble the epilator. Cleaning the precision epilator 1 Clean the precision epilator regularly by removing loose hairs with the cleaning brush. Do not switch on the appliance while brushing. 2 Rinse the precision epilator under the tap and shake off excess water. [. . . ]