User manual PHILIPS HP 6577

[. . . ] HP6577 User manual 1 English 6 Français 20 한국어 35 繁體中文 49 简体中文 62 88 101 HP6577 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. €1) 1 Epilating discs 2 Epilating head 3 Opti-Light 4 On/off button -- Press once for speed II -- Press twice for speed I 5 Light for speed I 6 Light for speed II 7 Charging light 8 Epilator 9 Release button 10 Trimming comb 11 Shaving head 12 Basic epilation cap 13 Active hair-lift and massage cap 14 Adapter 15 Cleaning brush 16 Pouch Important Read this user manual carefully before you use the epilator and save it for future reference. -- If you charge the epilator in the bathroom, do not use an extension cord. [. . . ] If you want to use the shaving head in the bath or shower, we advise you to use your common shower gel for a more gentle shave. 12 English 1 Press the release button (1) and remove the epilating head from the epilator (2). Note:You can remove the shaving head in the same way. 2 Put the shaving head on the appliance and press it until it snaps home. 4 Place the shaving head at an angle of 90° onto your skin with the on/ off button pointing in the direction in which you are going to move the appliance. 5 Slowly move the appliance against the direction of hair growth. Note: Make sure that the shaving head is always fully in contact with the skin. 6 Shave your bikini line as shown in the figure. Stretch the skin with your free hand and move the appliance in different directions. English 13 7 Shave your underarms as shown in the figure. Move the appliance in different directions and raise your arm to stretch the skin. Note:When you use shaving foam or gel, clean the shaving head during and after each use with water to ensure optimum performance. 8 When you have finished shaving, switch off the appliance and clean the shaving head according to the instructions in chapter ‘Cleaning and maintenance’. 9 Put the trimming comb on the shaving head when you store the appliance. Trimming with the comb Use the shaving head with the comb attached to trim your hairs in the bikini line to a length of 3 mm. You can also use the comb to pretrim long hairs (longer than 10 mm) on the underarms or legs. 1 Press the release button (1) and remove the epilating head from the epilator (2). 2 Put the shaving head on the appliance and press it until it snaps home. Note:To avoid overheating of the appliance, do not press it too hard onto your skin. The appliance works best when you move it over your skin without excessive pressure. If the overheat protection is activated, the appliance switches off automatically and the charging light and the speed lights flash red for 30 seconds. You can deactivate the overheat protection by letting the appliance cool down and then switch it on again. [. . . ] €  When the charging light lights up red continuously, the batteries are empty and you need to charge the epilator for approx. Note: You have to charge the epilator fully before first use. To deactivate the travel lock, press and hold the on/off button for 3 seconds until the speed lights flash white 2 times. You can also connect the epilator to the mains with the adapter to deactivate the travel lock. [. . . ]