User manual PHILIPS HQ 7895

[. . . ] HQ7895, HQ7890 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 EnglisH 6 Dansk 18 DEutscH 30 Español 44 suomi 57 Français 69 nEDErlanDs 82 norsk 95 107 svEnska 120 italiano 132 HQ7895, HQ7890 6 EnglisH introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Important Read this user manual carefully before you use the shaver and the Jet Clean system. Save the user manual for future reference. [. . . ] EnglisH 11 using the Jet clean system 1 Place the shaver in the holder and completely push down the lever tolocktheshaverintoplace. 19) The cleaning light starts flashing and the shaver is automatically lowered into the cleaning fluid. , Duringthefirstphaseofthecleaningprogram, theshaver automatically switches on and off several times and is put in differentpositions. Note: If you press the start button or open the lever during cleaning, the cleaning program is aborted and reset. In this case, the cleaning light stops flashing and the holder returns to its starting position. Note: If the adapter is removed from the wall socket during cleaning, the cleaning program is aborted. The holder remains in its current position. When the adapter is put back into the wall socket, the holder moves to the highest position. Note: If the fluid volume in the cleaning chamber drops below the minimum level during the cleaning program, the program is aborted. The cleaning light flashes with intervals and the holder returns to its starting position. Cleaning the Jet clean system The cleaning chamber is not dishwasher-proof. Clean the cleaning chamber every two weeks. 12 EnglisH 1 Simultaneously press the buttons on both sides of the Jet Clean system(1)andlifttheJetCleansystemoffthecleaningchamber (2). 21) You can simply pour the cleaning fluid down the sink. Make sure the release buttons snap back into place. 5 CleantheJetCleansystemwithamoistcloth. Cleaning the shaver under the tap Becarefulwithhotwater. 3 Rinse the hair chamber and the inside of the shaving unit under a hottapforsometime(Fig. 4 Rinse the outside of the shaving unit under a hot tap for some time(Fig. 6 Open the shaving unit again and leave it open to let the shaver dry completely(Fig. You can also clean the hair chamber without water with the brush supplied. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. [. . . ] Long hairs may obstruct the shaving heads. Clean the cutters and guards with the brush supplied (see chapter `Cleaning and maintenance'). The shaver does not work when I press the on/off button. Recharge the battery (see chapter `Charging') or connect the shaver to the mains. [. . . ]