User manual PHILIPS HQ560

[. . . ] This emulsion is applied to the skin during shaving. The Nivea for Men shaving emulsion prepares the skin and beard for the shave, ensuring that the shaver moves smoothly over your face and makes perfect contact with the skin. You will enjoy an unexpectedly close and comfortable shave and your skin will feel soft and fresh afterwards. After shaving, you can clean the appliance by simply rinsing it under a hot tap. Grooming sideburns and moustaches s Push the release slide downwards and remove the cover from the cartridge compartment. Charging the shaver s Slide the cartridge with inserted connector into the Trimmer The shaver has a separate trimmer for grooming sideburns and moustaches. [. . . ] Fitting the trimmer onto the shaver Switch off the shaver. Clean the shaver before you assemble the trimmer. s Press the release button and pull the shaving unit off Important: only leave the shaver to charge in a dry place!First put the plug in the appliance and then put the Powerplug in the socket. The Powerplug has an automatic voltage selector and is suitable for mains voltages ranging from 100 to 240 Volts. The pilot light near the ON/OFF button will go on. It will take the appliance approximately 8 hours to recharge completely. A fully recharged shaver has a shaving time of approximately 30 minutes. The shaver has been equipped with a `battery low' indication: the pilot light will light up when the battery is running low. 1 shaver. Replacing an empty cartridge s Push the release slide downwards and remove the cover from the cartridge compartment. Remove the empty cartridge and pull out the connector. s Remove the hairs with the brush supplied. Cause 3: shaving heads are damaged or worn ­ Replace the shaving heads s Remove the retaining plate. Remove the old shaving heads from the shaving unit and replace them with new ones. Damaged or worn shaving heads (cutters and guards) must only be replaced by the original Philishave Cool Skin shaving heads (HQ 156)!s Put the retaining plate back onto the shaving unit. Cover of cartridge compartment cannot be closed Cause 1: the cartridge has not been inserted correctly s Insert the cartridge correctly. The cartridge only fits properly into the shaver in one way. Cause 2: The cartridge has not been pushed far enough into the shaver. s Press the cartridge until it is properly fixed. Shaver does not work when the ON/OFF button is pressed Cause 1: the battery is empty s Recharge the battery. Cause 2: the appliance is connected to the mains. s Remove the Powerplug from the wall socket and pull Disposing of the battery When you discard your shaver in due course, please make sure that the battery is not thrown away with the normal household waste. [. . . ] Cause 2: the appliance is connected to the mains. s Remove the Powerplug from the wall socket and pull Disposing of the battery When you discard your shaver in due course, please make sure that the battery is not thrown away with the normal household waste. Remove the battery from the shaver and hand it in at an official collection point. Tip: you may also take or send your Philishave Cool Skin shaver to a Philips Service Centre. There, the battery will be removed and disposed of in an environmentally safe way. open. [. . . ]