User manual PHILIPS HQ564

[. . . ] Hold the shaver against the skin. s Press the yellow pump button to apply Nivea for Men shaving emulsion to the skin. When sufficient shaving emulsion has been released, start moving the shaving heads rapidly over your skin, making both straight and circular movements. The shaver is suitable for use in the shower. Introduction Cool Skin is a new shaving system by Philishave. [. . . ] Replace the cover and close it. About the built-in battery The shaver has been equipped with a built-in rechargeable battery. To prolong the life of the battery, recharge and store the appliance at a temperature between +5°C and +35°C. Also make sure that you disconnect the shaver from the mains when you are not recharging it. About the cartridge The Nivea for Men shaving emulsion in this cartridge will keep when it is stored at a temperature between 0°C and +40°C. 4222 001 83073 3 Cleaning and maintenance If you were charging the appliance, pull the Powerplug out of the wall socket and remove the appliance plug from the shaver . Clean the shaving unit with very hot water after every shave. The shaver is fully water resistant and therefore allows easy and quick cleaning. Important: the Powerplug is not waterproof. Prevent it from getting wet and do not immerse it in water!Shaving unit s Press the release button and flip the shaving unit Storage The pouch has been designed to hold the appliance, its dust cover, two spare cartridges and the Powerplug. The pouch is washable; wash it separately (see washing instructions on the inside of the pouch). Troubleshooting Shaving heads do not move smoothly over the skin Cause: not enough Nivea for Men shaving emulsion has been applied. s Press the pump button a few times until a sufficient amount of Nivea for Men shaving emulsion has been released to allow the shaving heads to move smoothly over your skin again. Reduced shaving performance Cause 1: the shaving heads are dirty s The shaver has not been cleaned immediately after use and/or has not been rinsed long enough or hot enough. Clean the shaver thoroughly before you continue shaving (see `Cleaning and maintenance'). Cause 2: long hairs are obstructing the shaving heads ­ Clean the cutters and guards s Remove the retaining plate. [. . . ] Let the shaver run until it stops. s Remove the screws. The Nivea for Men shaving emulsion has lost its colour or has turned watery. Cause: the Nivea for Men shaving emulsion has not been preserved at the right temperature. In case of other problems Please visit the Philips Web site at www. philips. com or consult the Philips Customer Care Centre in your country (you will find its phonenumber in the worldwide guarantee leaflet). [. . . ]