User manual PHILIPS HQ6/3

[. . . ] You can also shave without charging by connecting the shaver to the mains. You empty C As soon asgreenstart charging theon. Shaver, the pilot light goes When the battery has been fully charged, the green pilot light starts blinking. On C The red pilot light goesyou when the battery is almost empty. [. . . ] Do not recharge the shaver in a closed cassette. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the battery has been fully charged. 1 2 Remove the appliance plug from the shaver before you start shaving. Move the shaving heads quickly over your skin, making both straight and circular movements. Shaving on a dry face gives the best results. Your skin may need 2 or 3 weeks to get accustomed to the Philishave system. Put the protection cap on the shaver every time you have used it, to prevent damage. The trimmer can be activated while the motor is running. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Always check if the water is not too hot, to prevent your hands from getting burnt. Contact the Customer Care Centre in your country about the availability of this accessory. - HQ110 Philishave shaving head cleaner (shaving head cleaning spray). Do not throw the battery away with the normal household waste, but hand it in at an official collection point. You can also take the appliance to a Philips service centre, which will remove the battery for you and will dispose of it in an environmentally safe way. Only remove the battery if it is completely empty. 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Let the shaver run until it stops, undo the screws and open the shaver. Do not connect the shaver to the mains again after the battery has been removed. If you need information or if you have a problem, please visit the Philips Web site at www. Com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. The shaver has not been rinsed long enough or the water used was not hot enough. [. . . ] The shaver has not been rinsed long enough or the water used was not hot enough. Clean the shaver thoroughly before you continue shaving (see chapter 'Cleaning maintenance'). Unit by Remove the shaving heads from the shaving unit. C Remove the hairs from the cutters and guards with the brush supplied. [. . . ]