User manual PHILIPS HQ6095

[. . . ] Charging Make sure the appliance is switched off before you start to charge it. To prevent the battery from going flat during shaving, you can also charge the shaver in between shaves, even if the battery is not completely empty yet. Do not leave the appliance connected to the mains for more than 24 hours. Charge indications , , , The light ring goes on. [. . . ] HQ6075/HQ6073: Store the appliance in the pouch. 3 Press the on/off button once to switch on the shaver. 4 Put the protection cap on the shaver every time you have used it, to prevent damage (Fig. Trimming For grooming sideburns and moustache. The trimmer can be activated while the motor is running. Cleaning and maintenance Regular cleaning guarantees better shaving performance. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the appliance. Always check if the water is not too hot, to prevent your hands from getting burnt. Every day: shaving unit and hair chamber , , 1 Open the trimmer by pushing the slide Replacement Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ64 Super Lift & Cut Shaving Heads (HQ6073/HQ6095) or HQ8 Precise Cutting System Shaving Heads (HQ6075). 1 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Open the shaving unit and pull it off the shaver. You can also leave the shaving unit attached to the shaver. 3 HQ6075: Remove the retaining frame (Fig. 4 HQ6073/HQ6095: Open the shaving unit, turn the wheel anticlockwise (1) and remove the retaining frame (2). 2). Battery running low HQ6075/HQ6073: When the battery is running low, the red battery symbol starts burning. When you switch off the shaver, the red battery symbol starts to flash. 2) HQ6095: There is no warning or indication that the battery is running low. The appliance switches off automatically when the battery is completely empty. Charging the appliance supplied (your shaving heads may differ from the one shown in the figure) (Fig. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. shaving unit and then put the retaining frame back into the shaving unit (Fig. Make sure that the projections of the shaving heads fit into the recesses. 4 Clean the cutters and guards with the brush - 5 HQ6075: Put the shaving heads back into the Charge the appliance when the red battery symbol burns or flashes (HQ6075/HQ6073) or when the motor stops or starts running slower (HQ6095). 1 Put the appliance plug in the shaver (Fig. 3 Remove the powerplug from the wall socket and Cordless shaving time 6 HQ6073/HQ6095: Put the shaving heads back into pull the appliance plug out of the shaver when the battery has been fully charged. the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise (your shaving heads may differ from the one shown in the figure). [. . . ] 4222. 002. 5092. 1 2/5 Guarantee & service If you need information or if you have a problem, please visit the Philips website at www. philips. com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. Frequently asked questions Question Why doesn't the shaver shave as well as it used to? [. . . ]