User manual PHILIPS HQ6725

[. . . ] Introduction The shaver comes with two different kinds of NIVEA FOR MEN cartridges: Extra Fresh Shaving Gel for a fresh sensation during and after shaving and Moisturising Shaving Lotion for sensitive skin. This gives you the opportunity to try them out and discover which one suits your skin type best. , Extra Fresh Shaving Gel NIVEA FOR MEN Extra Fresh Shaving Gel refreshes the skin during shaving. It softens the beard hairs and lets the shaver glide gently over the skin while ensuring proper skin contact, resulting in a closer shave. [. . . ] 2 Remove the empty cartridge and pull out the pump. 3 Push the pump into a new cartridge until it locks into position with a click. 4 Slide the cartridge with the pump into the shaver. It only fits properly if the white side of the pump is pointing upwards. Using the appliance Shaving 1 Press the on/off button once to switch on the shaver. 2 Press the yellow pump button to apply NIVEA FOR MEN shaving gel/lotion to your skin. Move the shaver over your skin, making both straight and circular movements. 3 While shaving, press the pump button frequently to apply more NIVEA FOR MEN shaving gel/lotion so that the shaver keeps gliding smoothly over your face. , When you have run out of shaving gel/lotion, you can also use the shaver without it on a dry face. , Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 4 Press the on/off button once to switch off the shaver. Remove the cartridge if you are not going to use the appliance for more than one week. 6 Put the protection cap on the shaver every time you have used it, to prevent damage. Clean the shaver before you attach the trimmer (see chapter `Cleaning and maintenance'). 2 Press the release button (1) and pull the shaving unit off the shaver (2). 3 Tilt the trimmer slightly backwards and fit it onto the shaver. 4 Remove the trimmer by pressing the release button again and pulling the trimmer off the shaver. To maintain optimal shaving performance and to keep the shaver clean, you have to thoroughly rinse the shaving unit and hair chamber with hot water after every shave. Always check if the water is not too hot, to prevent your hands from getting burnt. Shaving unit and hair chamber 1 Switch off the shaver. 2 Press the release button (1) and open the shaving unit (2). 3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. [. . . ] Com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Troubleshooting 1 The shaving heads do not move smoothly over the skin. , Cause: not enough shaving gel/lotion has been applied. [. . . ]