User manual PHILIPS HQ6831

[. . . ] The segments indicate how much energy there is still left in the batteries. The shaving time of a fully charged shaver will range from 55 to 70 minutes, depending on your Running low C Batteriesbatteries are running low, the plug When the symbol will start blinking after you have switched the shaver off. When you switch the shaver on or off, the light in the display goes on for approx. Press the on/off button a few seconds until all symbols appear on the display. [. . . ] the powerplug is suitable for mains voltages ranging from 110 to 240V. You can also shave without charging by connecting the shaver to the mains. To extend the lifetime of the batteries, remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the batteries have been fully charged. Insert the appliance plug into the shaver as far as the line on the plug. Do not recharge the shaver in a closed pouch. When charging for the first time or after a long period of disuse: leave the shaver to charge continuously for 4 hours. Remove the powerplug from the socket and pull the appliance plug out of the shaver when the batteries have been fully charged. With the special Philishave Car Cord (HQ6010), you can also charge the appliance at 12 volts (e. This cord is available from your Philishave dealer. Move the shaving heads quickly over your skin, making both straight and circular movements. Make sure that the projections of the shaving heads fit exactly into the recesses. Replace damaged or worn shaving heads with Philishave HQ6 Quadra Action shaving heads only. The stand can be used surface or attached to the wall. To attach the stand to the wall: 1 Remove the base from the holder by turning and pulling the holder. Do not throw the batteries away with the normal household waste, but hand them in at an official collection point. You can also take the batteries to a Philips Service Centre, which will dispose of them in an environmentally safe way. Only remove the batteries if they are completely empty. 1 Remove the mains plug from the socket and pull the appliance plug out of the shaver. Let the shaver run until it stops, undo the screws and open the shaver. Do not connect the shaver to the mains again after the batteries have been removed. [. . . ] The shaver has not been rinsed long enough or the water used was not hot enough. Clean the shaver thoroughly before you continue shaving (see 'Cleaning'). C Cleancleancuttersthan one cutter and guard at Do not more A time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. [. . . ]