User manual PHILIPS HQ 6950

[. . . ] - If the mains cord is damaged, always have it replaced with one of the original type in order to avoid a hazard. Caution - Always put the protection cap on the shaver to protect the shaving heads when you are travelling. Never immerse the appliance in water, nor rinse it under the tap. - Noise level: Lc = 64 dB(A) Compliance with standards This Philips appliance complies with all standards regarding electromagnetic fields (EMF). [. . . ] 3 Press the release button (1) and remove the shaving unit (2). 4 Clean the inside of the shaving unit and the hair chamber with the cleaning brush. Every two months: shaving heads 1 Switch off the shaver. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. 2 Press the release button (1) and remove the shaving unit (2). 4 Remove the cutters and guards and clean them with the cleaning brush supplied. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. Put the retaining frame back into the shaving unit, push it down (1) and turn the wheel clockwise (2). 8 Put the shaving unit back onto the shaver. Extra through cleaning For extra thorough cleaning, put the shaving heads in a degreasing liquid (e. To remove the shaving heads, follow steps 1 to 4 described above. After cleaning, lubricate the central point on the inside of the guards with a drop of sewing machine oil to prevent wear of the shaving heads. Trimmer (all types except HQ6920) Clean the trimmer every time you have used it. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. 2 Clean the trimmer with the cleaning brush supplied. Tip: Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replacement Replace the shaving heads every two years for optimal shaving results. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. 2 Press the release button (1) and remove the shaving unit (2). 4 Remove the shaving heads and place new ones in the shaving unit. 5 Put the retaining frame back into the shaving unit, push it down (1) and turn the wheel clockwise (2). [. . . ] You have not cleaned the shaver well enough or you have not cleaned it for a long time. Clean the cutters and guards with the cleaning brush supplied. see chapter `Cleaning and maintenance' , section `Every two months: shaving heads'. Replace the shaving heads every 2 years for optimal shaving results. [. . . ]