User manual PHILIPS HQ7141

[. . . ] - Water may leak from the socket at the bottom of the appliance when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliance is safe to use based on scientific evidence available today. [. . . ] 3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. , Make sure you clean the inside as well as the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 5 Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. Every six months: shaving heads 1 Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. Trimmer Clean the trimmer every time you have used it. 1 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Clean the trimmer with the brush supplied. 3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replacement , Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philips shaving heads only. note: Do not mix up the cutters and the guards to guarantee optimal shaving performance. 1 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 4 Remove the shaving heads and place new ones in the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. Make sure that the projections of the shaving heads fit exactly into the recesses. [. . . ] Guarantee & service If you need information or if you have a problem, please visit the Philips website at www. Com or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. [. . . ]