User manual PHILIPS HQ7300

[. . . ] - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Children should be supervised to ensure that they do not play with the appliance. - The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. - The powerplug contains a transformer. [. . . ] The trimmer can be activated while the motor is running. Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the appliance when you rinse it. Every day: shaving unit and hair chamber 1 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Press the release button to open the shaving unit. 3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. , Make sure you clean the inside as well as the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. Every six months: shaving heads 1 Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit and turn the lock clockwise. Trimmer Clean the trimmer every time you have used it. 1 Switch off the shaver, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Clean the trimmer with the brush supplied. 3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months. [. . . ] Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. The shaver has not been rinsed long enough or the water used was not hot enough. 2 The shaver does not work when the on/off button is pressed. 3 The shaving unit has come off the shaver. [. . . ]