User manual PHILIPS HQ7740

[. . . ] Introduction The shaver comes with two different kinds of NIVEA FOR MEN cartridges: Extra Fresh Shaving Gel for a fresh sensation during and after shaving and Moisturising Shaving Lotion for sensitive skin. This gives you the opportunity to try them out and discover which one suits your skin type best. Important Read this user manual carefully before you use the appliance and save it for future reference. - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] 3 Move the shaving heads over your skin, making both straight and circular movements. 4 While shaving, press the pump button frequently to apply more NIVEA FOR MEN shaving gel/lotion so that the shaver keeps gliding smoothly over your face. Do not press the shaver too hard against your skin while shaving. If you prefer, you can wet your face before shaving. , For the best shaving results , shaving gel/lotion should be pumped up frequently. , The shaver will not perform optimally when used without shaving gel/lotion. , Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Switching off the shaver 1 Press the on/off button once to switch off the shaver. Remove the cartridge if you are not going to use the appliance for more than one week. 3 Put the protection cap on the shaver every time you have used it, to prevent damage. Clean the shaver before you attach the trimmer (see chapter `Cleaning and maintenance'). 2 Press the release button (1) and pull the shaving unit off the shaver (2). 4 Fit the trimmer onto the shaver (you will hear a click). 2 Remove the trimmer by pressing the release button again and pulling the trimmer off the shaver. To maintain optimal shaving performance and to keep the shaver clean, you have to thoroughly rinse the shaving unit and hair chamber with hot water after every shave. Always check if the water is not too hot, to prevent your hands from getting burnt. Cleaning Shaving unit: Quick Clean after every shave 1 Make sure the appliance is switched on. 3 Rinse the shaving unit and the hair chamber under a hot tap by letting the water run through the openings below the shaving unit for at least 30 seconds. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Shaving unit and hair chamber: every week We advise you to clean the appliance thoroughly at least once a week to maintain optimal shaving performance. You can also follow this procedure when the shaving heads have to be cleaned. 6 Make sure the inside of the shaving unit and the hair chamber have been cleaned properly. [. . . ] If there is no Customer Care Centre in your country, go to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV. Troubleshooting 1 The shaving heads do not move smoothly over the skin. - Cause: not enough shaving gel/lotion has been applied. Press the pump button a few times until sufficient NIVEA FOR MEN shaving gel/lotion has been released to allow the shaving heads to move smoothly over your face again. [. . . ]