User manual PHILIPS HQ7800

[. . . ] Read these instructions for use carefully before using the appliances and save them for future reference. The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. [. . . ] The cleaning light starts burning continuously. After the cleaning program, the shaver automatically returns to its starting position and the charging program is started. If you press the start button or open the lever during cleaning, the cleaning program is aborted and reset. In this case, the cleaning light stops blinking and the holder returns to its starting position. If the powerplug is removed from the wall socket during the cleaning program, the holder will remain in its current position. When the powerplug is put back into the wall socket, the holder will move to the highest position. C When the cleaning light starts burning clean. continuously , the shaver is hygienically If the shaver also needs to be charged, you can simply leave it in the appliance after the cleaning process. Clean the cleaning chamber every two weeks. Simultaneously press the buttons on both sides of the washing machine (1) and lift the washing machine off the cleaning chamber (2). Pour any remaining cleaning fluid out of the cleaning chamber. The cleaning fluid can simply be poured down the sink. Carefully place the washing machine back over the cleaning chamber. Make sure the release buttons snap back into place. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. You clean C Make sure the shavingthe inside as well as the outside of unit. 4 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads. Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. Cleaning the shaver with the brush supplied Shaving heads Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). [. . . ] Bend the 4 hooks aside (1) to take out the power unit (2). Remove the power unit cover by means of a screwdriver. Be careful, the battery strips are very sharp. Do not connect the shaver to the mains again after the battery has been removed. [. . . ]