User manual PHILIPS HQ8170CC

[. . . ] Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Important Read this user manual carefully before you use the shaver and the washing machine and save it for future reference. - The shaver and the washing machine are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of these appliances by a person responsible for their safety. [. . . ] 1 Simultaneously press the release buttons on both sides of the cleaning chamber (1) and lift the washing machine off the cleaning chamber (2). 2 Unscrew the dosing cap from the bottle with HQ200 Cleaning Fluid and remove the airtight seal. Make sure the release buttons snap back into place. 5 Put the appliance plug in the washing machine and put the powerplug in the wall socket. Using the washing machine 1 Place the shaver in the holder and push the lever down completely to lock the shaver into place. The charging light on the washing machine flashes to indicate that the shaver is being charged. The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , During the cleaning program , which takes approx. 1 hour, the cleaning light flashes continuously. , During the first phase of the cleaning program, the shaver automatically switches on and off several times and is put in different positions. , During the second phase of the cleaning program , the shaver is placed in the drying position. It stays in this position until the end of the program. Note: If you press the start button or open the lever during cleaning, the cleaning program is aborted and reset. In this case, the cleaning light stops flashing and the holder returns to its starting position. Note: If the powerplug is removed from the wall socket during cleaning, the cleaning program is aborted. the holder remains in its current position. When the powerplug is put back into the wall socket, the holder moves to the highest position. Note: If the fluid volume in the cleaning chamber drops below the minimum level during the cleaning program, the program is aborted. The cleaning light flashes with intervals and the holder returns to its starting position. 1 Simultaneously press the buttons on both sides of the washing machine (1) and lift the washing machine off the cleaning chamber (2). 2 Pour any remaining cleaning fluid out of the cleaning chamber. You can simply pour the cleaning fluid down the sink. [. . . ] 4 Undo the three screws in the power unit. 5 Bend the 4 hooks aside (1) to take out the power unit (2). 6 Remove the power unit cover with a screwdriver. Be careful, the battery strips are very sharp. [. . . ]