User manual PHILIPS HQ 8255

[. . . ] - Charge (all types except HQ8200), use and store the shaver at a temperature between 10°C and 35°C. - Always put the protection cap on the shaver to protect the shaving heads when you are travelling. - The shaver and the other accessories are not dishwasher-proof. - Never use water hotter than 80°C to rinse the shaver. [. . . ] 1 HQ8200: Put the small plug in the shaver and put the adapter in the wall socket. 4 After trimming, close the trimmer (`click') and switch off the shaver. 5 HQ8200: Remove the adapter from the wall socket and pull the small plug out of the shaver. Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. Always check if the water is not too hot, to prevent your hands from getting burnt. - You can clean the bathroom stand (HQ8251/ HQ8250 only) and the outside of the shaver with a damp cloth. Note:Water may leak from the socket at the bottom of the appliance when you rinse it. Cleaning the shaving unit under the tap 1 Switch off the shaver and disconnect it from the mains. 3 Rinse the shaving unit and hair chamber under a hot tap for some time. - Make sure that you clean the inside as well as the outside of the shaving unit. Always check if the water is not too hot, to prevent your hands from getting burnt. 4 Close the shaving unit and shake off excess water. Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving heads and the coupling spindles. 5 Open the shaving unit again and leave it open to let the shaver dry completely. Cleaning the shaving unit with the brush supplied 1 Switch off the shaver and disconnect it from the mains. Each shaving head consists of a cutter and a guard. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 5 Put the shaving heads back into the shaving unit. 6 Put the retaining frame back into the shaving unit and turn the lock clockwise. Note: If the shaving unit does not close smoothly, check if you have positioned the shaving heads properly and if the retaining frame is locked. Cleaning the trimmer with the brush supplied Clean the trimmer every time you have used it. [. . . ] Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. Troubleshooting 1 The shaver does not shave as well as it used to. Clean the cutters and guards with the brush supplied (see chapter `Cleaning and maintenance'). 2 The shaver does not work when I press the on/off button. [. . . ]