User manual PHILIPS HQ8445

[. . . ] If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. Make sure the powerplug does not get wet. Use and store the appliance at a temperature between 5cC and 35cC. The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. [. . . ] Every day: shaving unit and hair chamber When you clean the appliance, it is not necessary to take the shaving heads (cutters and guards) apart. If you want to take them apart, be sure not to mix up the cutters and guards, since grinding of the cutters in the guards only guarantees optimal performance for each matching set. If you accidentally mix up the sets, it could take several weeks before optimal shaving performance is restored. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Make sure the inside of the shaving unit and the hair chamber have been cleaned properly. Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the shaving unit and hair chamber without water by using the brush supplied. - Carefully clean the top of the shaving unit with the brush. - Carefully clean the inside of the shaving unit and the hair chamber with the brush. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replace the shaving heads every 2 years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philishave Sensotec shaving heads only. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Remove the shaving heads and place new ones in the shaving unit in such a way that the parts with the small holes point towards the centre of the shaving unit. [. . . ] remove the hairs with the brush supplied. Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit, press the wheel and turn it clockwise. Remove the old shaving heads from the shaving unit and replace them with new ones Replace damaged or worn shaving heads with HQ8 Philishave Sensotec shaving heads only. [. . . ]