User manual PHILIPS HQ8865

[. . . ] Stop switching when the display of your choice appears and wait a few seconds. You will hear a beep to confirm your personal choice. You can change the display layout at any time. Attention:When you start using the appliance for the first time or after a long period of disuse, it could take several minutes before anything appears on the display! [. . . ] After 3 seconds the shaving unit symbol becomes visible for 3 seconds and you will hear a short confirming beep. If you have not reset the system after these two weeks, the system will automatically reset itself. The demonstration will start automatically, using the display layout you have selected. Make sure the appliance is switched off before you start charging it. When you charge the shaver for the first time or after a long period of disuse, let it charge continuously for 2. You can also shave without charging by connecting the shaver to the mains. Do not leave the appliance connected to the mains for more than 24 hours. Charge the appliance when the plug symbol and the number '0' (number layout) or the red block (stacked block layout) start blinking and you hear a few short beeps. Remove the powerplug from the wall socket and pull the appliance plug out of the shaver when the battery has been fully charged. As soon as the battery has been fully charged, the plug symbol appears and the word 'FULL' runs across the display every 9 seconds. Personal Comfort C The to adapt the shaverControl system allows you to your skin type. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. Put the retaining frame back into the shaving unit, press the wheel (1) and turn it clockwise (2). Clean the trimmer every time you have used it. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the trimmer with the brush supplied. Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replace the shaving heads every two years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philishave Sensotec shaving heads only. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Press the release button (1) and open the shaving unit (2). [. . . ] The shaver does not work when the on/off button is pressed Put the powerplug in the wall socket. Cause: water stays behind on the metal parts of the appliance after cleaning. To prevent scale deposits on the metal parts of the appliance, wipe the shaver dry with a towel or tissue after rinsing. Never wipe the shaving unit with a towel or a tissue, as this could damage the shaving heads. [. . . ]