User manual PHILIPS HQ 8870

[. . . ] As charging continues, more and more charge percentage indications will start to burn green to indicate to what level the batteries have been charged. Fully charged C Batteriesthe batteries have been fully charged, As soon as all charge percentage indications burn green. Number of charge percentage indications that burn green decreases too. Running low C Batteriesbatteries are running low, the When the 20% charge percentage indication turns red. [. . . ] Put the protection cap on the shaver every time you have used it, to prevent damage. The trimmer can be activated while the motor is running. The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Always check if the water is not too hot before you start cleaning the shaver under the tap. Never dry the shaving unit with a towel or tissue as this may damage the shaving heads. When you clean the appliance, it is not necessary to take the shaving heads (cutters and guards) apart. If you want to take them apart, be sure not Accidentally mix up the sets, it could take several weeks before optimal shaving performance is restored. Every day: shaving unit and hair chamber 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Make sure the inside of the shaving unit and the hair chamber have been cleaned properly. 4 5 Rinse the outside of the appliance. Close the shaving unit and shake off excess water. Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the shaving unit and hair chamber without water by using the brush supplied. - Carefully clean the top of the shaving unit with the brush. - Carefully clean the inside of the shaving unit and the hair chamber with the brush. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Lubricate the trimmer teeth with a drop of sewing machine oil every six months. Replace the shaving heads every 2 years for optimal shaving results. Replace damaged or worn shaving heads with HQ8 Philishave Sensotec shaving heads only. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. Remove the shaving heads and place new ones in the shaving unit in such a way that the parts with the small holes point towards the centre of the shaving unit. [. . . ] Do nota clean more than one cutter and guard at time, Since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. Put the retaining frame back into the shaving unit. Remove the old shaving heads from the shaving unit and replace them with new ones. [. . . ]