User manual PHILIPS HQ9170

[. . . ] Important Read these instructions for use carefully before using the appliance and save them for future reference. - The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. - The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. [. . . ] - Shaving on a dry face gives the best results. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 3 Switch the shaver off by pressing the on/off button once. 4 Put the protection cap on the shaver every time you have used it, to prevent damage. The trimmer can be activated while the motor is running. Cleaning and maintenance Clean the shaver when the tap symbol with blinking water drops appears on the display. The normal way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver. Always check if the water is not too hot, to prevent your hands from getting burnt. Every day: shaving unit and hair chamber 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Press the release button to open the shaving unit. 3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time. Make sure the inside of the shaving unit and the hair chamber have been cleaned properly. 5 Close the shaving unit and shake off excess water. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Open the shaving unit again and leave it open to let the appliance dry completely. You can also clean the hair chamber without water by using the brush supplied. Every six months: shaving heads 1 Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2). 2 Clean the cutters and guards with the brush supplied. Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. 3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit and turn it clockwise. [. . . ] 1 Remove the powerplug from the wall socket and pull the appliance plug out of the shaver. 2 Let the shaver run until it stops, undo the screws and open the shaver. Do not connect the shaver to the mains again after the battery has been removed. Guarantee & service If you need information or if you have a problem, please visit the Philips website at www. [. . . ]