User manual PHILIPS HQ9190CC

[. . . ] Important Read these instructions for use carefully before using the appliances and save them for future reference. , The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts. , The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. [. . . ] The trimmer can be activated while the motor is running. Cleaning and maintenance , The best and most hygienic way to clean the shaver is in the washing machine, but you can also clean the shaver by rinsing it under the tap or with the brush supplied. Clean the shaver when the tap symbol with blinking water jet appears on the display. Cleaning the shaver in the washing machine preparing the washing machine for use Fill the cleaning chamber before first use and when the cleaning light blinks to indicate that the fluid level is too low. When the fluid level drops below the minimum level, the cleaning light starts to blink with intervals and the holder returns to its starting position. If you use the washing machine to clean your shaver every day, you should refill the cleaning chamber approx. 1 Simultaneously press the release buttons on both sides of the cleaning chamber (1) and lift the washing machine off the cleaning chamber (2). 2 Unscrew the dosing cap from the bottle with HQ200 Cleaning Fluid and remove the airtight seal. Make sure the release buttons snap back into place. Using the washing machine 1 Place the shaver in the holder and push the lever down completely to lock the shaver into place. The charging light on the washing machine starts blinking to indicate that the shaver is being charged. 2 Press the start button to start the cleaning program. The cleaning light starts blinking and the shaver is automatically lowered into the cleaning fluid. , During the cleaning program , which takes approx. 1 hour, the cleaning light blinks continuously. , During the first phase of the cleaning program, the shaver automatically switches on and off several times and is put in different positions. , During the second phase of the cleaning program , the shaver is placed in the drying position. It stays in this position until the end of the program. The cleaning light starts burning continuously. Note: If you press the start button or open the lever during cleaning, the cleaning program is aborted and reset. In this case, the cleaning light stops blinking and the holder returns to its starting position. Note: If the powerplug is removed from the wall socket during cleaning, the cleaning program is aborted. [. . . ] , You can always return to the menu by pressing the on/off button for 3 seconds. Replacement Replace the shaving heads when the shaving unit symbol appears on the display. replace damaged or worn shaving heads with HQ9 Philips Shaving Heads only. 1 Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver. [. . . ]