User manual PHILIPS HQC688

[. . . ] Check if the voltage indicated on the mains plug corresponds to the mains voltage in your home before you connect the appliance. Make sure the appliance does not get wet. [. . . ] Do not charge the appliance for more than 24 hours. To clip with the hair clipper connected to the mains: Switch the hair clipper off, connect it to the mains and wait a few seconds before switching it on. If the battery is completely empty: wait a few minutes before switching the appliance on. Do not run the appliance from the mains when the battery is fully charged. Select the small or large comb attachment, depending on the desired hair length (see table). Slide the comb holder into the guiding grooves of the appliance until you hear a click. Turn the Precision Zoom Lock` to the desired hair length setting (see table). If a lot of hair has accumulated in the comb, remove the comb attachment and blow and/or shake the hair from the comb. Small comb setting hair length 1 4 mm 2 7 mm 3 10 mm 4 13 mm 5 16 mm 6 19 mm 7 21 mm Large comb setting hair length 8 24 mm 9 27 mm 10 30 mm 11 33 mm 12 35 mm 13 38 mm 14 40 mm Clean and recharge the appliance every time you have used it. Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance. 1 Make sure the appliance is switched off and disconnected from the mains before you start cleaning it. Clean the cutting unit and the inside of the appliance with the brush supplied. Push the cutting unit until you hear a click. A worn or damaged cutting unit should only be replaced with an original Philips cutting unit. [. . . ] Dispose of the battery and the other components in an environmentally safe way. Do not connect the appliance to the mains again after it has been opened! [. . . ]