User manual PHILIPS HQT885

[. . . ] This appliance is only designed for trimming the human beard. Do not use the appliance for any other purpose. Do not use the appliance when the cutting unit is damaged or broken, as this may cause injury. If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard. [. . . ] Using the appliance Corded trimming Do not run the appliance from the mains when the battery is fully charged. If the battery is low, you can also use the appliance from the mains: 1 Switch the trimmer off, connect it to the mains and wait a few seconds before switching it on. 2 If the battery is completely empty, wait a few minutes before switching the appliance on. Absorbing cut hairs The suction system is activated automatically as soon as you switch the appliance on. It absorbs cut hairs during every kind of use, i. Trimming with and without comb attachment and contouring. The flexible hair guide follows the contours of the face and directs cut hairs towards the nozzle of the vacuum mechanism. We advise you to empty the hair-collection chamber after each trimming session. When trimming long, dense beards it may also be necessary to empty the hair-collection chamber during the trimming session in order to maintain optimal suction performance (also see chapter 'Cleaning', section 'Hair-collection chamber'). To ensure optimal functioning of the vacuum system, do not cut off more than approx. 7mm of your overall beard length at a time. If you want to cut your beard shorter, repeat the process one or more times. If you are trimming for the first time, start with the maximum trimming length setting (9). 2 To trim in the most effective way, move the trimmer against the direction of hair growth. Make smooth and gentle movements and make sure the surface of the comb always stays in contact with the skin (fig. This allows you to create a 'stubble look' (fig. 2 Make well-controlled movements and touch the hair lightly with the trimmer (fig. Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance. Never use sharp or hard objects to clean the filter to avoid damaging it. And carefully clean the hair-collection chamber and the filter with the brush supplied (fig. 3 Clean the cutting unit and the inside of the appliance with the brush supplied (fig. Replacement Worn or damaged cutting units and filters should only be replaced with original Philishave replacement parts which are available at your dealer or at authorised Philips service centres. [. . . ] We advise you to empty the hair-collection chamber after each trimming session. When cutting long, dense beards it may also be necessary to empty the hair-collection chamber during the trimming session. 2 Is the hair-collection chamber or the filter wet?If one of these parts becomes wet, dry it carefully. [. . . ]