User manual PHILIPS HR1566

[. . . ] If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Keep the appliance out of the reach of children. Always insert the beaters or the kneading hooks into the mixer before you connect it to the mains. [. . . ] It may be necessary to turn the beaters or kneading hooks slightly while doing this. The plastic collar on the beater or kneading hook remains visible; the beater or kneading hook cannot be inserted further into the appliance. For the best result, put the liquid ingredients in the bowl first and then add the dry ones. 6 Press the holder release button and bring the mixer into horizontal position so that the beaters or kneading hooks are lowered into the ingredients (fig. Press the turbo button to mix more quickly or to increase the speed during heavy jobs, e. Press the spatula against the side of the bowl to mix the ingredients more quickly and efficiently. 8 When you have finished mixing, set the control slide to 0 and unplug the appliance. 9 Press the holder release button and tilt the holder with the mixer on it backwards (fig. 10 Push the control slide forward to the eject position to release the beaters or kneading hooks and remove them from the mixer (fig. 11 The mixer can be removed from the holder when the holder is in upright or horizontal position. Press the mixer release lever at the rear end of the holder and lift the mixer off the holder (fig. Mixing without the stand 1 Insert the beaters or kneading hooks into the mixer (follow the procedure as described above at point 3). Press the turbo button to mix more quickly or to increase the speed during heavy jobs, e. 4 If you want to stop mixing for a while, switch the appliance off and put it (with the beaters or kneading hooks still attached) onits heel until you continue (fig. 5 When you have finished mixing, set the control slide to 0 and unplug the appliance. Never immerse the motor unit in water nor rinse it under the tap. Wind the cord round the heel of the appliance and attach the loose end of the cord to the mixer housing by means of the cord clip supplied (fig. The following items are available from your Philips dealer for replacement or as extra accessories. [. . . ] Add 100g wholegrain rye flour within 20 seconds and mix until the ingredients are well mixed (approx. Add the rest of the wholegrain rye flour within 20 seconds and mix then the ingredients for 20 seconds using the turbo button. Let the mixer cool down to room temperature before using it again. [. . . ]