User manual PHILIPS HR 1618

[. . . ] Register your product and get support at www. νικα 30 Español 38 Suomi 46 Français 53 Italiano 61 Nederlands 69 Norsk 77 Português 84 Svenska 92 Türkçe 99 简体中文 107 123 130 HR1618 6 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Danger -- Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. [. . . ] 9 Caution: Do not mash hard or uncooked foods, as this may damage the potato masher. Caution: Do not tap the potato masher on the side of the pan during or after mashing. Caution: To avoid damage, never use sharp or hard objects to remove puree from the potato masher. 20 minutes, drain them and put them in a bowl. Tip:To get the best result, make sure the bowl is not more than half filled. 2 Connect the masher bar to the masher coupling unit (1) and turn it anticlockwise (2) (‘click’) (Fig. 3 Attach the masher paddle to the masher bar. €8) 4 Connect the potato masher to the motor unit (‘click’). €9) 5 Put the plug in the wall socket. 6 Place the potato masher in the bowl filled with potatoes. 8 Move the potato masher up and down for approx. Add milk little by little and continue until you have achieved the desired result. 9 Use a spatula (not included) to remove puree from the potato masher. Tip:You can enhance the flavour by adding salt or butter. Detaching the potato masher 1 Unplug the appliance. 2 Press both release buttons simultaneously to detach the potato masher from the motor unit (Fig. 3 Detach the masher paddle from the masher bar by turning the masher paddle clockwise. €11) 4 Turn the masher bar clockwise (1) and pull it off the coupling unit (2). €12) Note: Always clean the potato masher immediately after use (see chapter ‘Cleaning’ and the cleaning table). 10 English Compact chopper The chopper is intended for chopping ingredients such as nuts, meat, onions, hard cheese, boiled eggs, garlic, herbs, dry bread etc. Be very careful when you handle the chopper blade unit, the cutting edges are very sharp. Be particularly careful when you remove the blade unit from the chopper bowl, when you empty the chopper bowl and during cleaning. [. . . ] In this case you should switch off the appliance and let it cool down for 60 minutes. If the problem persists, please contact the nearest Philips Consumer Care Centre. Let the ingredients cool down to approx. 80°C/175°F before you process them. [. . . ]