User manual PHILIPS HR1721

[. . . ] Never place the blade unit onto the motor unit without having the (blender or mill) jar properly attached. If the blades get stuck, unplug the appliance before removing the ingredients that are blocking the blades. If necessary use a spatula to remove food from the wall of the jar after you have switched off the appliance. Always make sure that the blade unit is correctly assembled before you plug the appliance in and switch it on. [. . . ] 3 Close the lid by pushing it down and turning the lid clockwise until you hear a 'click' (fig. 4 Insert the measuring cup into the opening in the lid. 5 Turn the control knob to speed 1 or 2. Turn the control knob to 'pulse' position if you want to process ingredients very briefly. 6 Do not let the appliance run for more than 3 minutes at a time. disassembling the blender 1 Unplug the appliance. 2 Remove the lid with the measuring cup from the blender jar. 3 Remove the blender jar with the blade unit attached to it from the motor unit. 4 Always clean the removable parts immediately after use. Tips If you want to crush ice cubes, put not more than 6 ice cubes (of approx. 24x35x25mm) in the blender jar and turn the control knob to pulse position a few times. Cut meat or other solid ingredients into smaller pieces before putting them in the blender jar. Do not process a large quantity of solid ingredients at the same time. To get good results, we advise you to process these ingredients in a series of small batches. To make tomato juice, cut the tomatoes in four and drop the pieces through the opening in the lid onto the rotating blades. Filter Only types HR1724 and HR1727 With this filter you can make delicious fresh fruit juices, cocktails or soy milk . The filter prevents pips and skins from ending up in your drink. Do not put more than 50g of unsoaked dried soy beans or 150g of fruit in the filter at the same time. Preparing the filter for use 1 Mount the blender with the blade unit attached to it onto the motor unit (A) and fix it by turning it clockwise until you hear a click (fig. The blender jar can be mounted in two positions. Make sure that the grooves of the filter fit exactly onto the ribs inside the blender jar. How to use the filter 1 Place the lid (F) on the blender jar. [. . . ] Do not rinse the motor unit under the tap. do not use abrasives , scourers , alcohol , etc. Storage You can store excess mains cord by winding it round the base of the motor unit. Environment Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. [. . . ]