User manual PHILIPS HR2200/80 CHAUFFANT SOUP MAKER

[. . . ] -- Do not use the appliance if the plugs, the mains cord or the appliance itself are damaged. -- If the mains cord is damaged, always have it replaced with one of the original type in order to avoid a hazard. -- Make sure that your hands are dry when you insert the mains cord into the appliance and in the wall socket. -- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] -- Cut the ingredients in cubes of 2cm to get perfect results. -- Defrost ingredients before putting them in the jug. 3 Add water or another liquid to the ingredients in the jug (Fig. Make sure the water level is somewhere between the MIN and MAX indication. 5 Hold the motor unit above the jug with both connectors aligned and ----------- then lower the motor unit into the jug (Fig. 6 Put the small plug in the socket of the jug (1) and put the mains plug 7 Press the program selection button to select the desired Tip: If you prefer your soup even finer, or would like to do some blending in your chunky soup or compote,  select the manual blending program. press and hold the start/stop button to start blending. To stop blending, simply release the start/ stop button. , , The corresponding light goes on and the soup maker starts the cooking and/or blending process (Fig. , , When the program has finished, the appliance beeps. Note:You can stop the process at any time by pressing the start/stop button again. 9 Remove the mains plug from the wall socket and from the appliance. 10 Hold the handle of the jug with one hand and with the other hand lift Problem Cause Solution the motor unit off the jug by its handgrip (Fig. 11 You can now pour the soup, smoothie or compote into a Note: Clean the appliance after every use. see chapter ‘Cleaning’. Cleaning Always unplug the appliance before you clean it. Never immerse the motor unit or jug in water. Do not clean the motor unit in the dishwasher. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. Tip: Cleaning the jug and motor unit is easiest immediately after use. 1 Remove the small plug from the appliance and remove the plug from The motor unit does not fit onto the jug properly because there are too many ingredients in the jug. The light of the selected mode does not go on. [. . . ] Problem Cause Solution Select another program (see the You have selected the wrong program. You have exceeded Remove some of the ingredients the MAX indication. And make sure the ingredients are spread evenly over the bottom of the jug. The overflow sensor prevents the appliance from overflowing. [. . . ]