User manual PHILIPS HR2724

[. . . ] Do not use the appliance if the mains cord, the plug or other parts are damaged. If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Keep the appliance out of the reach of children. never exceed the maximum operating time of 10 minutes at all applications. [. . . ] Safety system This appliance is equipped with a non-resettable, current-sensitive glass fuse that cuts off the power supply in case of motor failure to prevent overheating of the appliance. the appliance is also equipped with mechanical protection. To protect the motor, the plastic gear has been designed to break if bones or utensils are fed into the appliance. When this happens, simply remove the gear and exchange it. Sistem de siguran Acest aparat este prevzut cu o siguran fuzibil care întrerupe alimentarea cu energie electric în cazul în care aparatul se supraînclzete. Make sure the cutting edges of the cutter unit are pointing outwards. Make sure the notch of the grinding disc fits onto the projection of the cutter housing. Do not overload the appliance during use by pushing too much meat into the cutter housing. 5 Use the pusher to gently push the meat into the cutter housing. Remove any meat left in the cutter housing by passing pieces of bread through it. Always switch off and unplug the appliance before removing accessories or cleaning the motor unit. remove the pusher and the feeding tray. Unscrew the screw ring and remove the grinding disc, the cutter unit and the worm shaft. Remove the cutter housing by pressing the release button and by turning the cutter housing to the right (see the Disassembly section, page 16). The cutter unit and grinding discs should be lightly brushed with fat or oil to prevent rusting. Do not clean the metal parts in the dishwasher, as dishwasher detergents will cause these parts to darken or oxidize. You can transport the appliance by carrying it by its hinged handle. To replace a broken gear: - Remove the worm shaft from the cutter housing. [. . . ] Is it possible to mince frozen meat with the meat mincer?I need a very high force to attach the cutter housing onto the motor unit. Always defrost meat before mincing it with the meat mincer. You have closed the screw ring very thight. [. . . ]