User manual PHILIPS HR3610

[. . . ] ⷠIf the mains cord of this appliance is damaged, it must only be replaced by Philips or their service representative, as special tools and/or parts are required. 1, page 3) A B C D E F G H I J K L M N O P Q R S T U Clip Front grille Hook Blade cap Fan blade Plastic collar Positioning holes Rear grille Oscillation knob Positioning pins Motor shaft Motor unit Sliding pipe Extension release button Fan stand Mains cord Control Panel Base opening Fan base Screws Remote control unit (For model HR 3615 only) two screws (T) provided. - Unscrew the plastic collar (F) from the motor unit (L) by turning the collar anti-clockwise. - Mount the rear grille (H) onto the motor unit (L) by matching the three positioning holes (G) on the rear grille to the three positioning pins (J) on the front of the motor unit. [. . . ] Do not leave empty battery in the appliance. If you do not intend to use the appliance for a considerable time, remove the battery. Height setting - Press the extension release button (N) and pull the sliding pipe (M) upwards or downwards to the desired height (fig. Lock the sliding pipe (M) at its lowest position ("Click") before moving the fan. Oscillation The fan will oscillate during operation when the oscillation knob (I) is in the down position. When the oscillation knob is in the up position, the fan does not oscillate (fig. Free neck positioning You can adjust the air stream direction in both horizontal and vertical direction. - Horizontally: Pull the oscillation knob (I) upwards and turn the motor unit (L) to the desired direction (fig. In the same manner the area through which the fan oscillates can be adjusted. You will hear a clicking sound while positioning. Pilot light "3" above the "ON· Pilot light "2" above the "ON· SPEED" button three times to switch on the fan at low speed. Pilot light "1" above the "ON· The fan will change speed at a random pattern, producing comfortable natural wind. SPEED" button once more, the fan will go back to high speed again. You can change the speed during operation. The other controls can only be used if the fan is switched on (i. Timer setting - Press the "TIMER" button once for automatic switching-off after one hour. Pilot light "1" above the "TIMER" button will come on. - Press the "TIMER" button twice for automatic switching-off after two hours. Pilot light "2" above the "TIMER" button will come on. - Press the "TIMER" button three times for automatic switching-off after four hours. [. . . ] 9 and pull the fan stand (0) out carefully. Cleaning - Always remove the plug from the mains socket before cleaning. - Clean with a soft dry or damp cloth, if required with a soapy detergent. Only: Fitting a different plug This appliance is fitted with a BS 1363 13 Amp. [. . . ]