User manual PHILIPS HR4330

[. . . ] This means: Position the Air Cleaner near the radiator or other source of heating (fig. Especially for allergic users it is advisable to use an Air Cleaner in both the bedroom and the living room and to let these run continuously. To purify effectively the air in a domestic room or an area of a room, all the air must pass the Air Cleaner filters 2 - 3 times per hour. Depending on the air contents of the room or area concerned: · One Air Cleaner type HR 4320 should be used for rooms / areas up to approx. [. . . ] On entering one of the channels of the filter a particle is centrifuged against the side of this channel. The air will pass through the channel but the particle remains stuck against the channel wall. This unique and patented filter ensures a long life How to use Important · Read these instructions in conjunction with the illustrations before using the appliance. ⷠDo not immerse the appliance in water or other liquids. Always disconnect the appliance from the wall socket before taking off parts and before cleaning. ⷠThe appliance can be cleaned with a damp cloth, if required with some detergent. ⷠWhen disassembling: do not touch moving parts. Allow the Rota filter to stop in its own time. Do not place the appliance on a soft surface such as a bed or couch. ⷠKeep the mains cord away from heated surfaces. ⷠIf the mains cord of this appliance is damaged, it must only be replaced by Philips or their service representative, as special tools and/or parts are required. ⷠSave these instructions for further reference. In general, it is not advisable to use it near an open hearth fire. 8) A B C D E Air inlets (3) Pre-filter Rota filter Fixing nut for Rota filter Hepa filters type HR 4320: 2 filters type HR 4330: 3 filters Pilot light "On" Air outlet Speed control O = off · = low speed · = normal speed turbo = high speed "Filter full" indicator Handle Cord storage · For quick air cleaning, set the speed selector to the "turbo" setting. After approximately half an hour, set the switch to the position for normal speed. ⷠTo maintain clean, fresh air in your room all the time, it is best to run your machine continuously on low or normal speed, depending on room size and the degree to which the air tends to contaminate. ⷠClean and replace your filters regularly, especially if the appliance is used in a smoky environment. How to clean or replace the filters General advice · Remove and clean the Pre-filter and the Rota filter at least every two months. [. . . ] Replacement Hepa filters New Hepa filters are available at your dealer under number HR 4920. Automatic overheating safety device To prevent damage and reduce safety risks the overheating safety device switches off the fan motor if it becomes too hot. To indicate that the appliance is still in switchedon position and connected to the mains, the pilot light will remain on. If this happens: - Set the speed selector to position O (= Off). [. . . ]