User manual PHILIPS HR4332

[. . . ] The air cleaner sucks in air though its front and both sides. the sucked-in air is filtered by the air cleaner. After filtering, clean air is blown out from the top of the appliance. To be able to remove even the smallest particles from the air, the air cleaner has been equipped with a unique threestage filter system. [. . . ] â· If the cord of this appliance is damaged, it may only be replaced by an authorised Philips service centre, since repair requires special tools and/or parts. Clean air in your house is a prerequisite for the prevention of inhalant allergies. Your Philips air cleaner will help you remove airborne particles from the air effectively. These particles also include allergens, such as house dust, pollen and pet allergens as well as viruses, bacteria and mould spores. When comparing air cleaners you will notice that a number of terms are used by suppliers as an indication of the effectiveness of their appliances. the standard that best reflects the effectiveness of an air cleaner is CADR (Clean Air Delivery Rate). In general, an air cleaner with a high CADR will remove particles from the air more quickly than an air cleaner with a low CADR. 1) A B C D E Air inlets Prefilter Locking button for Rota filter Rota filter HEPA filters type HR 4322: 2 filters type HR 4332: 3 filters HEPA filter replacement indicator Speed control O = off 1 = low speed 2 = normal speed turbo = high speed `On' pilot light Air outlet Handle Cord storage facility When you are using a heating device: position the air cleaner in such a way that the 5 airflow caused by the appliance coincides with the convective airflow of the heating device. You should therefore place the air cleaner next to the radiator or other heating appliance (fig. Particularly people who suffer from allergies are advised to put an air cleaner in the living room as well as in the bedroom and to let both air cleaners run continuously. As a rule, the air cleaner should be placed on the floor in a central position with its back against the wall (fig. You can also hang the air cleaner on the wall (fig. Excess cord can be stored at the back of the appliance (fig. This is advisable if the room is very big and/or has an irregular shape. In this case it is best to put both appliances against the same wall, yet as far removed from each other as possible. â· For proper cleaning of the air in a room, we advise you to use: - one HR 4322 air cleaner for rooms with a surface area of up to 30 m2 (75 m3). - one HR 4332 air cleaner for rooms with a surface area of up to 50 m2 (120 m3). For a continuous supply of fresh, clean air in your room, run the appliance continuously at low (1) or normal (2) speed. â· For quick air cleaning, set the speed control (G) to the turbo setting and switch to speed 1 or 2 after approximately 30 minutes. Opening the air cleaner Note that the front of the air cleaner has been provided with an automatic safety lock which makes it impossible for you to open the appliance while it is running. [. . . ] If this happens: - Set the speed control to position O (= off). Make sure that the filters are not covered or blocked and that the airflow is not obstructed. - Check if the Rota 19 filter is able to rotate freely by turning it with your hand (fig. Put the plug in the wall socket and switch the appliance back on. [. . . ]