User manual PHILIPS HR4345

[. . . ] This is especially advisable if the room is very large and/or has an irregular shape. In such a case it is best to place the appliances as far apart as possible but against the same wall. When using heating appliances: place the Air Cleaner so that the air stream it generates coincides with the convection air stream produced by the heater. This means: Position the Air Cleaner next to the radiator or other source of heating (fig. [. . . ] 15) The indicator light above the on/off button comes on and the display lights up orange. The appliance starts operating at speed 1. If you selected "Auto" within the first three minutes after you switched the appliance on, the "Auto"indicator light will flash orange for a max. Of three minutes while it measures the air quality in the room. The digits will scroll faster if you press and hold the button pressed-in longer. If the air is clean, the Air Cleaner switches to the stand-by position and the "Auto" indicator light will turn green (fig. The indicator light above the on/off button will remain on. If the smoke sensor detects pollution, the "Auto" indicator light will remain orange continuously and the appliance will switch automatically to speed 1, 2 or turbo (fig. If you wish to quit the "Auto" function, press the "Auto" button again. The indicator light above this button will go out. how to set the clock · When connecting the Air Cleaner to the mains (and also after a power failure) the clock must be set (again). Using the timer, you can set how long and at what speed you wish the Air Cleaner to operate. If you want to use the Air Cleaner for a number of hours during or after smoking. You may also find the timer handy if you often use the appliance for the same period of time. After switching on, the timer counts down the set operating time and then switches the Air Cleaner off. You can program the Air Cleaner in the "Auto" function or in a speed you select. How to set/change the timer setting How to switch off the timer - To switch off the timer (prematurely), press and hold the "time setting" button (M) for at least 3 seconds (fig. ("Auto" or with the manual speed selector. Fast timer setting If you had previously programmed an operating time for the appliance, you can use this setting again quickly and simply: - Switch the appliance on (fig. 32) - Press and hold the "time setting" button (M) (at least for 3 seconds) until "OFF" and the timer symbol Ò come on (fig. Watching the clock while the timer is counting down The "OFF" symbol comes on and the display shows 0:00 or the previously set operating time. After 3 seconds the colon starts flashing to indicate that the timer is counting down from the set time. [. . . ] If the automatic overheating device is activated repeatedly, it is advisable to take the appliance to your dealer for technical inspection. Fitting a different plug This appliance is fitted with a BS 1363 13 Amp. Should you need to replace the plug, connect the wires as follows: Brown wire to the Live (L) terminal of the new plug. Blue wire to the Neutral (N) terminal of the new plug. [. . . ]