User manual PHILIPS HR8378

[. . . ] To connect the hose to the appliance, push it into the appliance and turn it clockwise. To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the appliance. Connect the tube to the handgrip by pressing the springloaded lock button on the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in the tube ("click"). [. . . ] The brush nozzle can be used for cleaning computers, bookshelves etc. The small nozzle can be used for vacuum cleaning small areas, e. Pull the cord out of the appliance and put the mains plug in the wall socket. To carry the appliance, put the handle in upright position and lift the appliance by the handle. You can adjust the suction power during vacuum cleaning: Adjust the suction power by means of the electronic suction power control (specific types only). Make sure the - and + poles are pointing in the right direction. With the infrared remote control you can set the suction power to one of 5 different suction power settings. When you switch the appliance on, it will always start running at the highest suction power setting. By pushing the - button, you will reduce the suction power by one setting. By pushing the + button, you will increase the suction power by one setting. Push the standby button to temporarily switch the vacuum cleaner off, for instance when you have to move some furniture. Remove the mains plug from the wall socket. Put the appliance in upright position and attach the lower tube to the appliance by means of the clip. The height of the clip can be adjusted by sliding it along the tube. Replace the dustbag as soon as the "dustbag-full indicator" changes colour (when the nozzle is not placed on the floor). When you do this, the dustbag will be automatically sealed. Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder. You cannot close the cover if no dustbag has been inserted. 1 Replace the Motor Protection Filter when you insert the first of a new set of dustbags or once a year. Insert the filter into the appliance with the white side facing upwards. The AFS Micro Filter in this appliance will remove a large part of the smallest particles from the exhaust air by means of its electrostatically charged fibres. Replace the AFS Micro Filter when you insert the first of a new set of dustbags or once a year. [. . . ] You can also take the batteries to a Philips service centre, which will dispose of them in an environmentally safe way. If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips, as special tools and/or parts are required. Set the electronic suction power to a higher setting (specific types only). Switch the vacuum cleaner on to make the airflow suck the obstructing material out of the blocked-up item. [. . . ]