User manual PHILIPS HS015

[. . . ] Move it slowly upwards and then away from the head, cutting only a small amount at a time. In the same manner cut the hair at the sides and the back of the head (fig. - If you want the hair cut on the sides or back of the head shorter than on top, change to a lower hair length setting and continue to cut against the direction of the hair growth. Cutting over styling comb or fingers If you want to cut the hair to a length of more than 17 mm, you can use the "over styling comb" method. [. . . ] Cut the hair from the back side of the neck towards the crown (fig. - Cut the sides of the head making overlapping strokes straight upwards (fig. Move the clipper slowly through the hair, leaving the hair on top of the head uncut. - If you wish you can cut the hair at the neck and sides a second time, using a lower position (i. - For a flat top look, cut the hair on the top of the head over a styling comb or over the fingers (fig. 31, 32) using the hair clipper without comb attachment. Short cut - Comb the hair into its natural direction. - Select the desired hair length for the back and the sides of the head. - Cut the back and the sides of the head making overlapping strokes straight upwards (fig. Move the clipper slowly through the hair, leaving the hair on top of the head uncut. Start at the front side and work towards the crown. hold the comb attachment flat against the head. - For outlining use the hair clipper without comb attachment. 1) A Comb attachment (adjustable to various hair lengths, removable) B Cutting unit (removable) C Cutting length control (press and slide) D On/off switch | = On O = Off E Socket for appliance plug (low-voltage DC) F Appliance plug (low-voltage DC) G Mains plug with built-in transformer H Brush I Oil J Styling comb Making the hair clipper ready for use Dependent upon the required application, you can use your hair clipper with or without the comb attachment. if mounted , the comb attachment can be set to 7 cutting length positions. You can slide the control knob when the release button (on top of the knob) is kept pressed-down. When released, the control knob is locked in the selected position. Keeping the control knob pressed-down (1), slide (2) it into one of the 7 positions. Clipping without comb attachment - Pull the comb attachment from the appliance (fig. - Insert the mains plug into the wall socket (fig. [. . . ] â· Let the person whose hair you are going to cut sit so that the top of his/her head is on your eye level. Before you start cutting, comb the hair well. It is not necessary to wash the hair before cutting. The best results will be achieved if the hair clipper is used on dry hair. [. . . ]