User manual PHILIPS HS025

[. . . ] For short hair, a light trimming at the neck and sides may be all that is needed for a well-groomed haircut. Hair cutting with comb attachment (4-17 mm remaining hair length) - Begin with the setting for maximum hair length (i. After you have familiarized yourself with the product and have gained some experience, you may select a particular hair length. - You can select seven hair length settings (see fig. [. . . ] (If the battery is completely empty: wait for about one minute. 5) and use the hair clipper directly from the mains. Making the hair clipper ready for use Dependent upon the required application, you can use your hair clipper with or without the comb attachment. if mounted , the comb attachment can be set to 7 cutting length positions. You can slide the control knob when the release button (on top of the knob) is kept pressed-down. When released, the control knob is locked in the selected position. Keeping the control knob pressed-down (1), slide (2) it into one of the 7 positions. Clipping without comb attachment - Pull the comb attachment from the appliance (fig. Ensure that your movements are well-controlled, especially when using without comb attachment. Touch the hair lightly with the hair clipper. 9) off the hairs from the top of the clipper. While clipping with comb attachment: If much hair has accumulated in the comb area, pull off the comb attachment (fig. If the cutting speed decreases it may be necessary to remove, clean and lubricate the cutting unit. It is advisable to clean the cutting unit and start recharging directly after use. Cleaning: after each use - Switch off (fig. - Clean the cutting unit and the inside of the appliance using the brush (fig. 14); - Lubricate the cutting unit with five drops of oil (fig. 16) and push until you hear a click (fig. Replacement cutting unit Use only an original Philips replacement cutting unit to replace a worn or damaged cutting unit. Protecting the environment Remove the rechargeable battery when eventually discarding your hair clipper. - In general, it is advisable to start from the neck and work towards the top of the head. Next cut the front and the top of the head (fig. [. . . ] - For a flat top look, cut the hair on the top of the head over a styling comb or over the fingers (fig. 34, 35) using the hair clipper without comb attachment. Short cut - Comb the hair into its natural direction. - Select the desired hair length for the back and the sides of the head. [. . . ]