User manual PHILIPS HS080

[. . . ] Please read these instructions carefully in conjunction with the illustrations before using the appliance. Take care when using the trimmer for the first few times. [. . . ] There is no danger if your trimmer remains connected to the mains. But in order to guarantee the longest possible working life of the battery do not charge for more than 24 hours. How to use the trimmer Before trimming always comb your beard and/or moustache using a fine comb. â· Beard trimming: with comb attachment - Initially use the position for maximum hair length: set the "zoom ring" to position 6 (fig. - For most effective cutting, move the trimmer against the direction of beard growth (fig. There are 6 positions: position 6 5 4 3 2 1 hair length (mm) 17 14 11 8 5 2 (very short: stubbly beard) Cutting single hairs, trimming and shaping of full beards: without comb attachment - Pull the comb attachment from the appliance (fig. - Ensure that your movements are well-controlled. Touch the hair lightly with the trimmer (fig. During use: - If much hair has accumulated in the comb area, pull off the comb attachment (fig. After every use: - Push the cutting unit release button to push the cutting unit backwards (fig. Every month: - Clean the cutting unit thoroughly and lubricate with a few drops of the light oil provided (fig. Cut/clip off the tip of the oil container spout to open. Replacing the cutting unit If damaged or worn, replace the cutting unit as follows: - Remove the old cutting unit by pushing it backwards (fig. - Take the new cutting unit and place its two notches into the guide slots (fig. [. . . ] - Separate the battery from the soldered joint with a screwdriver (fig. Do not connect the appliance to the mains supply after the battery has been removed. [. . . ]