User manual PHILIPS HTS5550

[. . . ] Register your product and get support at www. philips. com/welcome HTS5540 HTS5550 Register your product and get support at www. philips. com/welcome HTS5540 HTS5550 EN User manual DA Brugervejledning DE Benutzerhandbuch EL ES Manual del usuario FI Käyttöopas NL Gebruiksaanwijzing PL Instrukcja obsãugi PT Manual do utilizador SV Användarhandbok TR Kullan×m k×lavuzu FR Mode d'emploi IT Manuale utente Contents 1 Notice Copyright Compliance Mains fuse (UK only) Trademarks 8 2 2 2 2 2 3 3 4 4 5 5 5 7 7 7 8 8 9 9 9 10 11 11 12 12 12 12 13 13 13 14 14 14 15 15 15 15 9 Product speciÀcations Troubleshooting 16 17 19 English 10 Index 2 Important Safety Product care Disposal of your old product and batteries 3 Your home theater Main unit Remote control 4 Connect your home theater Connectors Connect to the TV Connect audio from TV or other devices Connect a wireless module 5 Use your home theater Before you start Choose your sound Play a disc Play from a USB storage device More play features Play from radio Play audio from TV or other devices Play from an MP3 player Use Philips EasyLink Create MP3 audio files 6 Change settings Access the setup menu Change general settings Change audio settings Change video settings Change preference settings 7 Update software Check software version Update software from a CD-R or USB EN 1 1 Notice Mains fuse (UK only) This product is fitted with an approved moulded plug. Should it become necessary to replace the mains fuse, this must be replaced with a fuse of the same value as indicated on the plug (example 10A). The replacement fuse must comply with BS 1362 and have the ASTA approval mark. If the fuse is lost, contact your dealer in order to verify the correct type. [. . . ] Press and hold AUDIO SYNC until the audio sync message appears on the display panel. Press +/- within five seconds to sync the audio with your video. 1 2 Quick skip play to a speciÀc time Quick skip to a specific part of a video by entering the time of a scene. Press the Navigation buttons and OK to select: · [TT Time] : Title time. · [Track Time] : Track time. 1 2 3 Enter the time of the scene, then press OK. EN 11 Play from radio The home theater can store up to 40 radio stations. » "AUTO INSTALL. . . PRESS PLAY' appears on the display panel if you have not installed any radio stations. Press . Use Philips EasyLink The home theater supports Philips EasyLink, which uses the HDMI CEC (Consumer Electronics Control) protocol. EasyLinkcompliant devices that are connected through HDMI connectors can be controlled by a single remote control. Note · Philips does not guarantee 100% interoperability with all HDMI CEC devices. 1 2 3 Press the following buttons to control play: Action Button Selects a preset radio station. Press and hold to erase the preset radio station. Press to stop the installation of radio stations. PROGRAM Manual: Press once to access program mode, and press again to store the radio station. Automatic: Press and hold for five seconds to reinstall radio stations. / Note · AM and digital radio are not supported. · If no stereo signal is detected, or if fewer than five stations are found, you are prompted to install the radio stations again. · For the best reception, place the antenna away from the TV or other sources of radiation. 1 2 3 4 5 Switch on the HDMI CEC operations on the TV and other connected devices. See the manual of the TV or other devices for details. Select and adjust the following settings: · · [EasyLink] : Enables or disables EasyLink. [One Touch Play] : Enables or disables One Touch Play. If enabled, you can use the remote control to start disc play in the home theater and the TV switches automatically to the correct channel. [One Touch Standby] : Enables or disables One Touch Standby. If enabled, the home theater can be switched off to standby by a remote control from the TV or other connected HDMI CEC devices. [System Audio Control] :Enables or disables System audio control. [. . . ] · Ensure that the audio cables are connected and select the correct input source (for example, AUDIO SOURCE) for the device you want to play. · You might not hear any sound if the connected device is not HDCP (Highbandwidth Digital Content Protection) compliant or only DVI compatible. Use an analog or digital audio connection. · Ensure that the [HDMI Audio] is enabled. [. . . ]