User manual PHILIPS HX-6972

[. . . ] Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Important Read this user manual carefully before you use the appliance and save it for future reference. danger - Keep the charger and/or sanitiser away from water. [. . . ] features Easy-start This Sonicare type comes with the Easy-start feature activated. The Easy-start feature gently increases power over the first 14 brushings to help you get used to brushing with the Sonicare. Note: Each of the first 14 brushings must be at least 1 minute in length to properly move through the Easy-start ramp-up cycle. Deactivating or activating the Easy-start feature 1 Attach your brush head to the handle. Note: Using the Easy-start feature beyond the initial ramp-up period is not recommended and reduces Sonicare's effectiveness in removing plaque. Smartimer The Smartimer indicates that your brushing cycle is complete when it automatically switches off the toothbrush at the end of the brushing cycle. Dentists recommend brushing at least 2 minutes twice a day. Quadpacer The Quadpacer is an interval timer that has a short beep and pause to remind you to brush the 4 sections of your mouth. Depending on the brushing mode you have selected, the Quadpacer beeps at different intervals during the brushing cycle. To deactivate or reactivate the Quadpacer feature: 1 Place the handle with a brush head attached on the plugged-in charger. , You hear 1 beep to indicate the Quadpacer has been deactivated or you hear 2 beeps to indicate the Quadpacer has been activated. Cord wrap on deluxe charger (specific types only) If your type includes the deluxe charger cover and base, the travel charger is pre-installed inside the cover. If you want to shorten the mains cord, you can store excess cord in the cord wrap feature built into the charger base. 1 To separate the charger cover from the charger base, press the two grey snap bars on the charger base and pull the white charger cover upwards. 2 Wrap excess power cord around the grey charger base as shown in the picture. Be sure to wrap the cord on the inside of the two snap levers. 3 When you have stored the excess cord, guide the mains cord through the small groove in the rear of the grey charger base. 4 To reattach the charger cover, press it down over the charger base until it snaps into place. Tip: For extra convenience during travel, you can remove the travel charger and use it without the charger cover and charger base. Cord wrap on sanitiser with integrated charger (specific types only) If your type includes the sanitiser, you can store excess cord in the cord wrap feature built into the bottom of the sanitiser. Sanitising (specific types only) With the UV sanitiser you can clean your brush head after every use. Discontinue use of the sanitiser if the UV light bulb remains on when the door is open or if the blue window is broken or missing from the sanitiser. [. . . ] You can order replacement UV light bulbs from the Consumer Care Centre in your country or an authorised Philips service centre. Always remove the battery before you discard and hand in the appliance at an official collection point. dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. [. . . ]