User manual PHILIPS HX9112/02

[. . . ] Sonicare FlexCare Platinum 1 ENGLISH 4 FRANÇAIS 21 INDONESIA 40 BAHASA MELAYU 57 PORTUGUÊS DO BRASIL 76 TIẾNG VIỆT 94 ภาษาไทย 111 138 152 Sonicare FlexCare Platinum 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Important Read this user manual carefully before you use the appliance and save it for future reference. Danger -- Keep the charger and/or sanitiser away from water. [. . . ] The handle has to be fully charged and the Easy-start feature must be deactivated. Intensity levels per mode -- Low: 1 LED indicator light -- Medium: 2 LED indicator lights -- High: 3 LED indicator lights Note: to adjust the intensity level to the next higher or lower level, you can press the + button to increase intensity or the - button to decrease intensity at any time during the brushing cycle. Pressure Sensor A change in vibration (and a slight change in sound) alerts you when you apply too much pressure while brushing. ENGLISH 11 Battery status (when handle is not on charger) -- 1 yellow LED indicates a low charge. -- 3 green LEDs indicate a full charge. Note: If you hear a long beep and the yellow LED of the battery level indicator flashes, the rechargeable battery is empty and the Sonicare switches off. Place the handle on the charger to recharge it. Note:To keep the battery fully charged at all times, you can keep the Sonicare on the charger when you are not using it. Features Pressure Sensor This Sonicare comes with the Pressure Sensor feature activated. The Pressure Sensor works in all 3 modes and at all 3 intensity levels. To deactivate or reactivate the Pressure Sensor feature: 1 Place the handle with a brush head attached on the plugged-in charger or sanitiser. 2 Press and hold the power button and the mode button for 2 seconds. , , You hear 1 beep to indicate that the Pressure Sensor has been deactivated. , , You hear 2 beeps to indicate that the Pressure Sensor has been activated. 12 ENGLISH Quadpacer -- The Quadpacer is an interval timer that has a short beep and pause to remind you to brush the 4 sections of your mouth. Depending on the brushing mode you have selected, the Quadpacer beeps at different intervals during the brushing cycle. The Quadpacer works in all 3 modes and at all 3 intensity levels. The Quadpacer feature on this Sonicare has been activated. To deactivate or reactivate the Quadpacer feature: 1 Place the handle with a brush head attached on the plugged-in charger or sanitiser. 2 Press and hold the mode button for 2 seconds. , , You hear 1 beep to indicate that the Quadpacer has been deactivated. , , You hear 2 beeps to indicate that the Quadpacer has been activated. [. . . ] You can also contact the Philips Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Environment -- Do not throw away the appliance or the UV light bulb (bulb contains mercury) with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment. -- The built-in rechargeable battery of the Sonicare contains substances that may pollute the environment. [. . . ]