User manual PHILIPS LC434599

[. . . ] 8 Adjusting the focus and size of the image. 8 Adjusting the vertical and horizontal angle of the projector . 9 Inserting the batteries in the compact remote control . 9 Inserting the batteries in the trackball remote control . [. . . ] ­ If it does not: Check that you have switched on the remote control. If you have, check that the batteries are installed properly and/or replace the batteries. ­ If it does: Make sure that the USB cable has been properly connected. Installation Connecting to video equipment Note: The figures in brackets (1) correspond to the figures in the accessories diagram. The characters in brackets (a) correspond to the characters in fig. Always switch off the projector before making any connections. PAL, NTSC, SECAM (c) (d) Connecting to video equipment S-VHS (c) (e) Audio out USB R Audio in R L L Video S-Video Data out Data in D Da Audio out USB R Audio in R L L Video S-Video Data out Data in Data in Data out Projector (2) (optional) (3) Projector S-Video (2) VCR (3) 1. Connect the S-Video out socket of a S-VHS video recorder, Laser Disc player, video camera or TV to the S-Video socket (e) of the projector. Connect the Audio out L/R sockets of the S-VHS video recorder, Laser Disc player, video camera or TV to the Audio in L/R sockets (c) of the projector. For this, use the red and white audio connectors of the audio/video connection cable. Insert the white plug into the L socket and the red plug into the R socket. In case your VCR, Laser Disc player, video camera or TV is equipped with a Scart connector (depending on region): 1. Connect the Scart/RCA Audio Video adapter (3) supplied to the Scart connector of the VCR, Laser Disc player, video camera or TV. Plug the audio/video connection cable (2) supplied into both the adapter and the Audio in L/R sockets (c) of the projector. Insert the white plug into the L socket and the red plug into the R socket. Plug an (optional) S-Video connection cable into the VCR and the S-Video socket (e) of the projector. Video out R Audio L out S-Video Scart adapter (not for USA version) VCR R Audio R L L out Video out Scart adapter (not for USA version) 1. Connect the Video out socket of a VCR, Laser Disc player, video camera or TV to the Video socket (d) of the projector. For this, use the video/audio connection cable (2) supplied. Connect the Audio OUT L/R sockets of the VCR, Laser Disc player, video camera or TV to the Audio in L/R sockets (c) of the projector. For this, use video/audio connection cable (2) supplied. Insert the white plug into the L socket and the red plug into the R socket. [. . . ] Troubleshooting Image is blurred If a fault occurs, first check the points listed below before taking the projector for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service organisation. Warning: Under no circumstances should you try to repair the projector yourself as this could invalidate the warranty. Distance between projector and screen is not correct. [. . . ]