User manual PHILIPS LC443199

[. . . ] Philips multimedia projector cBright 2 Series User guide English Menu OK AV te Mu e Volum Stand by p Lam RC Keysto ne 0. Controls and connections 1 2 3 4 AV te Mu Menu OK 5 6 7 8 9 AV Mute Source Keystone Lamp Stand by @ $ @ 6 1 2 3 4 Laser Left Mouse MOUSE Volume VOLUME Right 1 2 !0 3 4 Menu MENU OK 5 6 7 Laser pointer remote control AV Mute AV MUTE Stand by On Source SOURCE D-Freeze D-FREEZE D-Zoom D-ZOOM 9 8 Compact remote control fig. 2 5 6 7 a b c d e f g h Audio out USB Video audio-in Data audio-in Video S-Video Data out Data in l k j i 2 Menu OK Stand by Volum e RC Lamp RC one Keyst 0 ! [. . . ] Always switch off the projector before making any connections. USB connection A USB interface is available via an upstream connector. When the projector's USB (upstream) connector is connected to a PC or an Apple Macintosh computer equipped with a USB downlink connection, it will identify as a USB device. It is possible to: ­ control the cursor of the computer via the projector remote control, ­ play audio information from the computer via the projector speaker, and ­ the display settings of the computer will be changed to fit the capability of the projector. Projector (1) (2) (1) Mac/PC (5) USB optional Philips VGA/MAC adapter Data out Data out Audio out Note: If you experience problems using the USB connection, please refer to the user guide or support information of your computer. 1. Connect the Data out terminal of the computer to the Data in terminal (h) of the projector and secure the plugs by tightening the thumb screws. For this, use the VGA/USB cable (1) supplied. Note: When connecting the projector to a Macintosh computer use a VGA/MAC adaptor (optional). The adapter is only needed if your computer is equipped with a 2 row, 15 pin connector. If your computer is equipped with a 3 row connector no adaptor is needed. Connect the USB (upstream) socket (b) of the projector to the USB downstream port of the computer. For this, use the VGA/USB cable (1) supplied. ­ You can now manipulate the mouse cursor on the computer and on the screen, using Cursor Control. Audio information from the computer will be played via the projector speaker. Notes: If the mouse cursor does not react when using the cursor control on the remote control: · Check that the batteries are installed properly and/or replace the batteries. · Make sure that the USB cable has been properly connected. · Check that the projector receives the signals from the remote control (LED ring around the Standby button will fast flash when receiving a signal). If no audio information is heard via the projector speaker: · Check (AV) Mute setting. · Connect the Audio out socket of the computer to the Data audio-in socket (d) of the projector. For this use audio/video connection cable (2) and adapter (5) supplied. Note: You can also make an Audio out connection to an external amplifier. See `Connecting to audio equipment'. 11 7. Installation Connecting to video equipment Connecting to video equipment Note: The figures in brackets (1) correspond to the figures in the accessories diagram. The characters in brackets (a) correspond to the characters in fig. [. . . ] · See warning messages on the start up screen for details. ­ red (fast blinking): lamp start has failed. · Disconnect projector from the mains. If this does not resolve the problem, replace the lamp. [. . . ]