User manual PHILIPS LFH9380

[. . . ] The material in this manual is believed adequate for the intended use of the system. If the product, or its individual modules or procedures, are used for purposes other than those specified herein, confirmation of their validity and suitability must be obtained. safety · To avoid a short circuit, do not expose the product to rain or water. ⷠDo not expose the device to excessive heat caused by heating equipment or direct sunlight. [. . . ] 5 Activate the Pocket Memo The Pocket Memo is turned on and off by sliding the ON/OFF switch. When using it for the first time, you will be prompted to set the language, date and time. D Note It is possible to change the language later using the menu. 2 Set the date and time When using the Pocket Memo for the first time, you will be prompted to set the current date and time. 1 Press the + or ­ button to change the value for the year, month or day. 1 Set the language When using the Pocket Memo for the first time, you will be prompted to set the language. After setting the day, press the smart button to advance the settings to the correct time. D Note If a mistake is made in setting the date/time, use the smart button any time during the procedure to step back to make corrections. If the Pocket Memo is not used for more than two hours, it turns off completely. Turn the unit on by moving the On/Off switch to the OFF position and then back to the ON position. 1 Create a recording Follow these steps to create a recording with the Pocket Memo: DPM 1 A memory card must be inserted into the memory card slot. 3 Insert and eject the memory card on page 9 for more information. The status LED glows in red (in overwrite mode) or green (in insert mode) while recording. ⷠThe following information is displayed: a Recording format b Recording time c Current position in the recording d File number e File name 3 Press the NEW smart button to create a new recording. D Note For best results, speak clearly and keep the microphone about four inches (ten centimeters) away from your mouth. Follow these steps to switch to insert mode to make additions to a recording: 1 Press the MENU button while in the stop position to open the menu. 4 Press the OK smart button to save the setting or press the CANCEL smart button to exit the sub-menu without changing the setting. 5 Press the + or ­ button to select the file into which the insertion should be made. In insert mode, the record position of the slide switch reads iREC and the status LED glows in green while recording. ⷠIn overwrite mode, the record position of the slide switch reads REC and the status LED glows in red while recording. 6 Play, forward or rewind to the position where the insertion should be made. 3 Finish (lock) a recording When a recording is finished and no additional changes will be made, follow these steps to mark it as finished and protect it from being accidentally deleted: 1 Press the + or ­ button while in the stop position to select the recording to be marked finished. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Philips may void the user's authority to operate the equipment. Cables Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations. [. . . ]