User manual PHILIPS LTC0350

[. . . ] Refer servicing to qualified service personnel. The exclamation mark within a triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important safety instructions Read Instructions: All safety and operating instructions should be read before the product is operated. Retain Instructions: The safety and operating instructions should be retained for future reference. [. . . ] Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the distance between the equipment and the receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any unauthorized modification to this equipment could result in the revocation of the authorization to operate the equipment. Lenses The camera is provided with a standard CS-mount. Therefore, a wide range of lenses can be used. For example: · fixed iris lenses · manual iris lenses · DC auto-iris lenses · active auto-iris lenses Notes 1. For indoor use, you can use a fixed iris lens. For outdoor applications, a DC or active autoiris lens is recommended. Try to avoid bright light sources in the camera's field of view when you use a fixed iris lens. When you use a DC or active auto-iris lens, the smear will be reduced. When you use a DC or active iris lens, it is recommended to set the Auto Electronic Shutter (AES switch; 8) to the `OFF` position. When an C/CS-mount adapter (optional) is used, C-mount lenses can also be applied. Installation (Figure 1, 2 & 3) Use this screw hole to mount the camera. Maximum allowed length of the screw is 8mm. The screw block can be mounted on the top or bottom side of the camera. [. . . ] Adjust the focus ring of the lens (if applicable) to the object distance. Unlock the back-focus mechanism by releasing screw approx. Adjust the back-focus distance by rotating screw until the image is sharp. [. . . ]